Barcol-Air CERA-1 User manual
INSTALLATION INSTRUCTIONS
2 - 10
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
2.2.
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
1.1. Preface
engineer and contains important information about installation, operation,
maintenance and technical faults. The installation engineer is responsible for
are used in this manual to draw attention to hazards, instructions or directions
relating to persons, product, system and/or the environment
.
Great care has been given to the writing of this manual but no rights may be
obtaineel from it. Barcol-Air reserves the right to amend products and
improvement in respect of our products, this document may vary from the
product with which you have been supplied. You can download the latest
version of this manual from our website:
www.cera-systeem.nl
.
This manual was originally drafted in Dutch.
1.2. Product description
CERA
=
C
entral
E
nergy
R
independent air volume control units (ventilation units) suitable for stacked
housing. The units have been designed particularly for systems with low noise
criteria and for the accurate measurement and control of air volumes courtesy
®
.
Barcol-Air B.V. was founded in 1982 as daughter company of the Barber
Colman Company. Since 2020 Barcol-Air is part of HC Groep
The Netherlands, a leading manufacturer of indoor climate technology.
Both national and international, Barcol-Air is wellknown for its knowledge on
air distribution, especially with regards to VAV and CAV systems. The product
T
+31 (0)299 689 300 |
E
www.barcol-air.nl
damage to the product, installation or environment.
environment.
NOTE
may be important for the installation, operation, control or maintenance
TIP
material damage.
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
2.1. Safety
used.
to the product.
are not allowed.
petrol, etc in the vicinity of the product.
has been disconnected from the power source. Secure the system so that it
cannot be switched on again unintentionally.
Always make sure that the power system to which the product is connected
• Never supply 230 Volt power to the wiring terminals.
2) and switches
shall not be combined with any other wiring and shall be wired seperately.
connection, without interruption by terminal blocks. All visible wiring shall
be protected as much as possible with cable protection.
ventilation system free of obstacles and dirt - valve settings may not
be altered.
(1) A qualifi ed installation engineer is someone who is employed by a central
heating or mechanical installation company that is registered at the Chamber
of Commerce.
2.2. Standards and guidelines
The installation engineer must ensure that the entire system meets the legal
requirements, the regulations set out in this document and other applicable
documentation supplied by the manufacturer. Any additions, amendments
or legal requirements that have subsequently come into force shall apply to
all legal requirements and regulations.
environmental hazards may remain after installation.
This also applies to other products included in the system.
standards and legislation of the country in which it is sold.
The application of the product outside the country concerned could
result in extremely dangerous situations!
X
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
Wall plugs and screws are not supplied. Good quality wall plugs and screws
must be used.
The weight of the units can be found in the dimensional tables in the technical
documentation.
The required diagrams are available upon request.
the cover to be fully opened.
ducts.
and the prescribed distance to the other walls. As per the following installation
drawing:
the standard regulations.
unnecessary pressure loss. Never use more duct than absolutely necessary,
unless this has been taken into account when making the calculations. You
must be replaced immediately. Minor damage to the outer sleeve shall be
repaired with tape.
• Pull the duct out fully.
• Measure the correct length and mark this point.
• Cut through the outer sleeve, the insulation material and the inner duct with
a sharp knife.
• Cut around the whole periphery and use a pair of pliers to cut through
the spiral winding of the inner duct. Cut away the excess spiral winding.
NOTE
E
=
A
+
75
2x M6 bout
1x borgschroef
=
Home side
Shaft side
2x M6 bolt
2x M6 bolt
1x locking screw
6 - 10
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
• Push the insulation and the outer sleeve back slightly and secure the inner
• Make sure the tape is applied half around the duct and half around
the connector.
Prevent the insulation from being in contact with the clip as this would mean
the connection is not air tight.
connector with the appropriate tape.
mentioned in the technical product documentation.
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
4. OPERATION | CONTROL
sensor(s)
will be determined by the manual setting of these valves. These settings must
level decreases again. The volume of air is limited to a
predetermined maximum.
2
sensor looks likes this:
•
Select this mode when cooking and/or showering. By pushing the switch
in both situations.
•
monitoring. Select this mode for the night (sleeping) time.
to Normal operation.
night mode daily and for a longer period, which will make a positive
contribution to reducing excessive contruction moisture (in addition to
other measures in this regard).
Please notify the supplier immediately of any damage to the device.
CAUTION
NOTE
correctly connected).
NOTE
NOTE
position is applied to prevent the presence of construction dirt in the units or
to prevent unnecessary draft in high-rise buildings as much as possible.
2sensor
Type:
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
The correct operation of the ventilation system during lifetime can only be
guaranteed if the system is inspected and maintained in accordance with
the following instructions. These instructions are based on normal
operating conditions.
not require any maintenance. We recommend the following actions:
2
-sensor.
6.1. CERA unit malfunctions
2
CAUTION
in a particularly polluted environment, then extra maintenance may be
needed.
CAUTION
left open, please notify the installation engineer.
• Orange seal
in the factory.
• Green seal
After the commissioning has been completed, the installation engineer will
apply a green seal. At that moment, the installation has been commissioned
and is ready for operation.
A blue seal is applied after maintenance work was carried out to
A standard two-year factory warranty applies to all Barcol-Air products. Within
this period, the product or component parts will be repaired or replaced without
charge according to the Barcol-Air warranty conditions.
Provisions and exceptions are included in our warranty conditions. Visit the
download center on our website
www.barcol-air.nl
for the full warranty
conditions and/or supplementary warranty periods or conditions.
Status: factory setting
CERA ready for installation
Status: after commissioning
CERA ready for operation
Status: after service/maintenance
Maintenance has been preformed
on the CERA unit
NOTE
Warranty claims are always handled through the installation engineer.
9 - 10
© 11-2020 Barcol-Air B.V. | T +31 (0)299 689 300 | www.barcol-air.nl | www.cera-systeem.nl | Changes w/o notice or obligation.
BARCOL-AIR |
T+31 (0)299 689 300 | Eexport@barcol-air.nl
WWW.BARCOL-AIR.NL
Other manuals for CERA-1
1
This manual suits for next models
7
Table of contents
Other Barcol-Air Fan manuals
Popular Fan manuals by other brands
Salda
Salda RIRS 3500VE-VW EKO 3.0 Technical manual
Westinghouse
Westinghouse ETL-ES-Alta Vista-WH22 owner's manual
Helios
Helios VDD T120 Series Installation and operating instructions
Titus
Titus DVCP Installation and operation manual
LUCCI
LUCCI AIRFUSION BREEZE installation instructions
ZIEHL-ABEGG
ZIEHL-ABEGG FB Series Translation of the original operating instructions
