Barpa NORMA 800 Series User manual

IM_03
SERIES NORMA 800 - 38U UP TO 47U
40x
M5x10bolt
72x
M6x12bolt
16x
M8x12 bolt
16x
M8 flange
nut
4x
key
4x
M12 adjustable
feet
Safety warning – Do not climb on, rock,
shake your rack. Only someone with good
mechanical skill and who has experience
should install this rack. Never exceed the
maximum load capacity. If you didn’t
understood this instructions manual
please contact us by inf[email protected]
In this first step you will need the top cover (5), the
bottom plate (10) and 2 x frame (6). Put the two parts of
frame ready to assemble this part like picture with 16 x
bolt M8*12 (C) and 16 x flange nut M8 (D);
With the cabinet in the vertical, assemble the mounting
angle (4) with 24 x bolt M6*12 (B) in the horizontal sides
of the cabinet;
This installation step is optional. With 24 x bolt M6*12 (B)
fix the mounting spacer to the mounting angle;
With the cable entry panel (11) and with the castors (12),
assemble in the bottom plate with 24 x bolt M5*10 (A);
This installation step is optional
1
1
2
2

IM_03
With 2 x bolt M5*10 (A) fix the accessory to the frame; Now assemble the front door (1) and the rear door (7)
you choose;
Put the side panels (2) and…
Cautions: To avoid any damage please ensure that is adequate space between each unit for good airflow. Take care to
not exceed the 40ºC – 104ºF temperature.
Accessories you can use with your Norma:
• Blank Panel;
• Shelfs;
• Sliding Shelf;
• Drawer;
• Digital Temperature Unit;
• Unit Fan’s;
• Cable Management;
• Password Lock.
With 12 x bolt M5*10 (A) fix the cable management (7) to
the mounting spacer;
You are ready to go!
Grab the 19’’ rails in the vertical and mount with 24 x bolt
M6*12 (B);
for more informations please go to www.barpa.eu
i j