barrier TBG3800 Operating and maintenance manual

TELESCOPIC
BOOM GATE
IP56_Installation Procedure - Telescopic Boom Gate © Copyright 2019 www.barriergroup.com.au
Models: TBG3800
Installation Procedure
Telescopic Boom Gate
The TBG3800 is a strut assisted light boom gate designed
for applications where there is restricted overhead space
to accommodate a fixed length boom, or insufficient room
for a swing gate. The telescopic boom can be locked off at
a fixed length if the available height allows or retracted as
the boom is raised. The gate can be used to span openings
from 2.3 to 3.8 metres.
Description: Telescopic light boom gate
Operation: Manual lift with gas strut assistance
Construction: Steel posts with aluminium rails
Gate Swing: 90 degrees vertical
Gate Stop: Built-in
Receiver Post: Included (optional wall mount receiver)
Max Opening: 3825mm
Min Opening: 2335mm
Mounting Type: Surface mounted posts
Rail Type: Aluminium telescopic 50dia. inner 63 dia. outer
Rail Height: 940mm to the centre of the rail
O/H Clearance 3450mm
Finish: Powder coated safety yellow

IP56_Installation Procedure - Telescopic Boom Gate © Copyright 2019 www.barriergroup.com.au
Operation side
Step 1:
Mounting the post in position to suit desired opening
Step 2:
Insert Boom
Step 3:
Adjust boom length to suit
Step 4:
secure boom
4200mm
CLEAR OPENING 3875mm
(4991mm)
2000mm
2650mm
CLEAR OPENING 2325mm
2500mm
(3451mm)
Max opening
Min opening
Operation side
Step 1:
Mounting the post in position to suit desired opening
Step 2:
Insert Boom
Step 3:
Adjust boom length to suit
Step 4:
secure boom
4200mm
CLEAR OPENING 3875mm
(4991mm)
2000mm
2650mm
CLEAR OPENING 2325mm
2500mm
(3451mm)

STEP 1:
Mounting the post in position to suit desired opening
Maximum and Minimum opening spacing as shown on previous page.
Drill the mounting holes using the posts as a guide and bolt them into in place with appropriate fixings to ensure they
are securely mounted.
STEP 2:
Insert assembled boom into the square receiver on the gate post as shown.
Tighten hex retainer bolt to secure boom.
Operation Side
IP56_Installation Procedure - Telescopic Boom Gate © Copyright 2019 www.barriergroup.com.au

IP56_Installation Procedure - Telescopic Boom Gate © Copyright 2019 www.barriergroup.com.au
STEP 3:
Adjust boom length to suit desired opening. Secure the length using the
thumb screw. Attention: Do not over-tighten! Test gate operation.
Important information.
Read carefully.
Keep this information for further reference.
WARNING
The gate will not provide optimum performance unless it is installed correctly. For
satisfactory gate operation please follow the instructions carefully.
NOTE: No guarantee will be given or responsibility accepted by the manufacturers if the gate
is not installed as instructed. Barrier Group do not warrant the work of 3rd party contractors.
BEFORE YOU START
1. The installer must ensure the desired mounting point for the gate is level, plumb and rigid.
2. Use fixings appropriate to the material into which they are being fixed (not included).
3. Check all parts are included. Contact Barrier Group immediately if you are missing a piece.
AFTER INSTALLATION CARE
Barrier Group recommends that you check the operation of your gate at least every six
months (more regularly in extreme environments or frequent use). It is natural for spring
assistance unit to lose tension over time. Adjustment may be required.