BAT LOGIC BasePlates User manual

WWW.BATLOGIC.NET
FOR FURTHER INFORMATION
PLEASE VISIT OUR WEBSITE
2 x BasePlates (1 x left & 1 x right) A
8 x 10mm Counter Sunk Screws (for most foot boards) B
8 x 12mm Counter Sunk Screws (for thicker foot boards) C
8 x Nuts (for the BasePlate) D
BasePlate pack contains:
ErgAdaptor
Enjoy all of the benefits
of the QuickRelease System
on the ergo. Click from
boat to erg.
Associated products:
SOLD
SEPARATELY
BASEPLATES WILL FIT ALMOST ALL
BOAT FOOT STRETCHERS AS STANDARD.
If not, you foot stretcher screw pattern can be adjusted.
CustomPack
Customize your
QuickRelease System
to adjust for leg length
discrepancy or added
heel load.
BAT LOGIC
BasePlates
FITMENT GUIDE
SAFETY WARNING: FISA approved heel restraints must be used while rowing. The QuickRelease System is not designed for walking. Walking on it may cause injury.
B C D
A
ShoePlate Tops
The ShoePlate Tops attach to
the Shoe and allow the shoe
to click into the BasePlates
which are axed to the boat
or ErgAdaptor. The ShoePlate
Tops are therefore required for
the system to function. Should
your rowers not already have
ShoePlate Tops for their rowing
shoes, you will need to purchase
these separately.
SOLD
SEPARATELY
Philips Head Screw Driver and Spanner
Equipment needed:

YOUR BOAT, YOUR SETTINGS, ANYTIME, ANYWHERE. BAT LOGIC.
BasePlates
FITMENT GUIDE
WWW.BATLOGIC.NET
FOR FURTHER INFORMATION
PLEASE VISIT OUR WEBSITE
STEP 2 – ENGAGE YOUR SHOEPLATE TOPS INTO THE BASEPLATE
Line up the ShoePlate Top with the front tab of the BasePlate and place it on top. Slide the ShoePlate Top upwards to engage into the BasePlate,
you should hear a click. Once engaged you should check the ShoePlate Top’s tab is fully depressed by pushing down on it. This ensures a proper
locked fitment. Clip on or tie on your FISA approved heel restraints. Repeat for each ShoePlate.
Pull up on the release tab located at the
toe of the ShoePlate Top to unlock it, slide
the ShoePlate Top downwards to disengage
from the BasePlate. You can now clip o or
untie your heel restraints.
Remove the boat foot stretcher. Place 1 x nut (D) in one of the 4 hexagonal cavities on the top of the BasePlate. Screw the BasePlate to the foot
stretcher using either screws (B) or (C) depending on the thickness of your foot stretcher. You will need to hold the nut as you screw the screw in
(as shown). Repeat this for all nuts (D) and screws (B) or (C). You will need 4 screws only for each side (leaving you with 8 unused screws B or C).
The QuickRelease System can
be attached to a steering plate
like a regular shoe. Simply fit the
BasePlates to the steering plate/disc
with the same instructions as above.
STEERING FOOT ATTACHMENT
STEP 1 – ATTACH THE BASEPLATE
STEP 3 – TO RELEASE
SHOEPLATE TOPS FROM
BASEPLATES