BAT LOGIC QuickRelease System User manual

WWW.BATLOGIC.NET
FOR FURTHER INFORMATION
PLEASE VISIT OUR WEBSITE
2 x ShoePlate Tops (1 x left & 1 x right) A
2 x BasePlates (1 x left & 1 x right) B
8 x 10mm Counter Sunk Screws (for most foot boards) C
8 x 12mm Counter Sunk Screws (for thicker foot boards) D
8 x Nuts (for the BasePlate) E
8 x 8mm Flat-Head Screws (for shoe attachment) F
SAFETY WARNING: FISA approved heel restraints must be used while rowing. The QuickRelease System is not designed for walking. Walking on it may cause injury.
QuickRelease System contains:
C D E F
ErgAdaptor
Enjoy all of the benefits
of the QuickRelease System
on the ergo. Click from
boat to erg.
Philips Head Screw Driver and Spanner
Equipment needed:
B
Associated products:
SOLD
SEPARATELY
A
THE QUICKRELEASE SYSTEM
IS COMPATIBLE WITH ALMOST ALL
ROWING SHOES.
CustomPack
Customize your
QuickRelease System
to adjust for leg length
discrepancy or added heel
load.
BAT LOGIC
QuickRelease System
FITMENT GUIDE

YOUR BOAT, YOUR SETTINGS, ANYTIME, ANYWHERE. BAT LOGIC.
QuickRelease
System
FITMENT GUIDE
WWW.BATLOGIC.NET
FOR FURTHER INFORMATION
PLEASE VISIT OUR WEBSITE
STEP 1 – ATTACH YOUR ROWING SHOES
Attach your rowing shoes +/- CustomPack to the ShoePlate Tops, using
your current screws or the 8 T-head screws (F) in the screw bag with
the red zip. Do not ever use counter sunk screws to fit the shoe to your
ShoePlates. The counter sunk screws supplied (C/D) are used to fit the
BasePlates to your boat foot stretcher. Tighten screws in a diagonal
pattern (i.e. top right to bottom left and then bottom right to top left).
STEP 3 – ENGAGE YOUR SHOEPLATE TOPS INTO THE BASEPLATE
Line up the ShoePlate Top with the front tab of the BasePlate and place it on top. Slide the ShoePlate Top upwards to engage into the BasePlate,
you should hear a click. Once engaged you should check the ShoePlate Top’s tab is fully depressed by pushing down on it. This ensures a proper
locked fitment. Clip on or tie on your FISA approved heel restraints. Repeat for each ShoePlate.
Pull up on the release tab located at the
toe of the ShoePlate Top to unlock it, slide
the ShoePlate Top downwards to disengage
from the BasePlate. You can now clip o or
untie your heel restraints.
STEP 4 – TO RELEASE
STEP 2 – ATTACH THE BASEPLATE
Remove the boat foot stretcher. Place 1 x nut (E) in one of the 4 hexagonal cavities on the top of the BasePlate. Screw the BasePlate to the foot stretcher
using either screws (C) or (D) depending on the thickness of your foot stretcher. You will need to hold the nut as you screw the screw in (as shown).
Repeat this for all nuts (E) and screws (C) or (D). You will need 4 screws only for each side (leaving you with 8 unused screws C or D).
The QuickRelease System can
be attached to a steering plate
like a regular shoe. Simply fit the
BasePlates to the steering plate/disc
with the same instructions as above.
STEERING FOOT ATTACHMENT
Do not overtighten – hand tight only if using a screw driver, if using a drill, 5Nm max torque.
Ensure all screws are
evenly tightened.