7
1300 886 649 Model: ALPB-315 Product Code: 49357 04/2015
www.tempo.org
AUS
Wall Mounting Instructions
Step 1: Attaching the wall plate
Tools required: Spanner wrench, Phillips head screwdriver, pencil, hammer,
drill and drill bits
Mounting to a brick or concrete wall
• Choose a solid wall area far away from any water source and direct
sunlight. Avoid hollow areas or the mortar joints between bricks.
• Using the wall plate and its built-in spirit leveller, outline the location of the
four holes on the wall (see Diagram 1, overleaf). Ensure the holes are level.
• Using an appropriate size masonry bit, pre-drill a 6cm deep hole in each
marked location (see Diagram 2, overleaf).
• Place the masonry plugs (B) into the holes and gently tap them with a
hammer until flush with the wall.
• Position the wall plate and insert the self-tapping screws (A) and flat
washers (D) into the plugs. Secure the wall plate to the wall, making sure
the upper and lower raised sections of the wall plate sit away from the wall
(see Diagram 3, overleaf).
IMPORTANT!
• This product can be mounted to a brick, concrete or stud wall. DO NOT
attach it to a hollow plasterboard wall or decorative wall divider.
• If you want to install the wall mount to a wood stud wall, use a
commercially available stud finder to locate the studs in the wall. If you
have any doubts regarding this installation, consult a professional installer
for advice.The wall must be structurally sound and strong enough
to hold the weight of the TV and wall mount. If your builder approves
mounting to a wood stud wall, follow the instructions on page 9.
• If you want to install the wall mount to a steel stud wall, purchase suitable
steel stud fasteners from your local hardware store. DO NOT use the
supplied large self-tapping screws in steel studs.
• Before installing the wall mount, make sure you have read and understood
all instructions. Also ensure that the wall is strong enough to hold the
weight of the TV as well as the wall mount.
