Baumatic BRUI 119 User manual

BRUI 119 Refrigerator

Noises during Operation
Changing the light bulb
12
8
8
15
14
13
18
17
16
14
4
7
7
SCRAPPING OLD APPLIANCES
Energy Saving
14
14
15
SAFETY INFORMATION
9
9

Thank you for purchasing this product.
Before using your refrigerator, please carefully read this instruction
manual in order to maximize its performance. Store all documentation
for subsequent use or for other owners. This product is intended solely for
household use or similar applications such as:
- the kitchen area for personnel in shops, offices and other working
en ironments
- on farms, by clientele of hotels, motels and other en ironments of a residential
type
- at bed and breakfasts (B & B)
- for catering ser ices and similar applications not for retail sale.
This appliance must be used only for purposes of storage of food, any other
use is considered dangerous and the manufacturer will not be responsible for
any omissions. Also, it is recommended that you take note of the warranty
conditions.

SAFETY INFORMATION
The refrigerator contains a refrigerant gas (R600a:
isobutane) an insulating gas (cyclopentane), with
high compatibility with the environment, that are,
however, infl ammable.
We recommen that you follow the following
regulations so as to avoi situations angerous
to you:
Before performing any operation, unplug the power
cor from the power socket.
• The refrigeration system positione behin an
insi e the Wine Coolers contains refrigerant.
Therefore, avoi amaging the tubes.
• If in the refrigeration system a leak is note , o
not touch the wall outlet an o not use open
flames. Open the win ow an let air into the room.
Then call a service centre to ask for repair.
• Do not scrape with a knife or sharp object to
remove frost or ice that occurs. With these, the
refrigerant circuit can be amage , the spill from
which can cause a fire or amage your eyes.
• Do not install the appliance in humi , oily or usty
places, nor expose it to irect sunlight an to
water.

• Do not install the appliance near heaters or
inflammable materials.
• Do not use extension cor s or a apters.
• Do not excessively pull or fol the power cor or
touch the plug with wet han s.
• Do not amage the plug an /or the power cor ; this
coul cause electrical shocks or fires.
• It is recommen e to keep the plug clean, any
excessive ust resi ues on the plug can be the
cause fire.
• Do not use mechanical evices or other equipment
to hasten the efrosting process.
• Absolutely avoi the use of open flame or
electrical equipment, such as heaters, steam
cleaners, can les, oil lamps an the like in or er to
spee up the efrosting phase.
• Do not use or store inflammable sprays, such as
spray paint, near the Wine Coolers. It coul cause
an explosion or fi re.
• Do not use electrical appliances insi e the foo
storage compartments, unless they are of the type
recommen e by the manufacturer.
• Do not place or store inflammable an highly
volatile materials such as ether, petrol, LPG,
propane gas, aerosol spray cans, a hesives, pure
alcohol, etc. These materials may cause an
explosion.
• Do not store me icine or research materials in the
Wine Coolers. When the material that requires a
strict control of storage temperatures is to be

6
store , it is possible that it will eteriorate or an
uncontrolle reaction may occur that can cause
risks.
• Maintain the ventilation openings in the appliance
enclosure or in the built-in structure, free of
obstruction.
• Do not place objects an /or containers fille with
water on the top of the appliance.
• Do not perform repairs on this Wine Coolers. All
interventions must be performe solely by
qualifie personnel.
• This appliance can be use by chil ren age from 8
years an above an by persons with re uce
physical, sensory or mental capabilities or with a
lack of experience an knowle ge; provi e that
they have been given a equate supervision or
instruction concerning how to use the appliance in
a safe way an un erstan the hazar s involve .
• Chil ren shoul not play with the appliance.
Cleaning an user maintenance shoul not be
ma e by chil ren without supervision

7
SCRAPPING OLD APPLIANCES
This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE)
WEEE contains both polluting substances (which can cause negative consequences for the
environment) and basic components (which can be re-used) It is important to have WEEE subjected to
specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all
materials
- WEEE should not be treated as household waste;
- WEEE should be handed over to the relevant collection points managed by the municipality or by
registered companies In many countries, for large WEEE, home collection could be present
In many countries, when you buy a new appliance, the old one may be returned to the retailer who has
to collect it free of charge on a one-to-one basis, as long as the equipment is of equivalent type and has
the same functions as the supplied equipment
Conformity
By placing the mark on this product, we are confirming compliance to all relevant
European safety, health and environmental requirements which are applicable in legislation
for this product
Energy Saving
For better energy saving we suggest :
Installing tge appliance away from heat sources and not exposed to direct sunlight and in a
well ventilated roo
Avoid putting hot food into the refrigerator to avoid increasing the internal temperature and
therefore causing continuos functionaliting of the compressor
Do not excessively stuff foods so as to ensure proper air circulation
Defrost the appliance in case there is ice to facilitate the transfer of cold
In case of absence of electrical energy, it is advisable to keep the refrigerator door closed
Open or keep the doors of the appliance open as little as possible
Avoid adjusting the setting to temperatures too cold
Remeve dust present on the rear of the appliance
Individuals can play an important role in ensuring that WEEE does not become an environmental issue; it
is essential to follow some basic rules:

Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in the lower
rear section of appliances, as poor air circulation can affect performance. Built-in appliances
should be positioned away from heat sources such as heaters and direct sunlight.
Climate class Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Position the appliance away from sources of heat such as stoves, radiators, direct sunlight etc.
Maximum performance and safety are guaranteed by maintaining the correct indoor temperature
for the class of unit concerned, as specified on the rating plate. This application perform well from
N to ST. The Appliance may not work properly if it is left for a longer period at a temperature
above or below the indicated range.
8

1
9

8

Tum the hinge over and place it on
the diagonally opposite comer of the
cabinet. Screw back in place.
Check that the
larder fridge door is
aligned horizontally
and vertically and
that the door seals
are secure on all
sides before finally
tightening the hinge
bracket screws.
10

11

12

13

Important!
Normally we advise you select setting of 2 or 3 or 4, if you want the temperature warmer or
colder please turn the knob to lower or higher setting accordingly.When you turn the knob to
lower which can lead to the more energy efficiency. Otherwise, it would result the energy-
consuming.
Setting “0” means:Off.
Turning clockwise in direction Refrigerating unit on, the latter
then operating automatically.
Setting “1” means:Highest temperature, warmest setting.
Setting “7” (end-stop) means:Lowest temperature,coldest
setting.
Important!
High ambient temperatures (e.g. on hot summer days) and a cold setting on the temperature re-
gulator (position 6 to 7) can cause the compressor to run continuously or even non-stop.
Reason:when the ambient temperature is high,the compressor must run continuously to maintain
the low temperature in the appliance.
Changing the light bulb
Noises during Operation
The following noises are characteristic of refrigeration appliances:
Clicks
Whenever the compressor switches on or off, a click can be heard.
Humming
As soon as the compressor is in operation, you can hear it humming.
When there is a LED lamp, please note:
This LED lamp has a longlife time. Once it is broken, it is mandatory to call aftersales center to
get a new one.
A replacement made by unqualified people without super ision from electrical engineer
would result in electrical shock and injury.
14

Bubbling
When refrigerant flows into thin tubes, you can hear bubbling or splashing noises.
Splashing
Even after the compressor has been switched off, this noise can be heard for a short time.
15

Defrosting in frozen-food storage compartment
Defrosting in freezer chamber is operated manually. Before defrosting, take the food out; take the
ice tray and drawers out or put them into the fresh food compartment temporarily, then set the
knob of the temperature regulator to position “0”(where the compressor will stop working) and
leave the door of the refrigerator open until ice and frost dissolve thoroughly and accumulation at
the bottom of the freezer chamber. Wipe off the water with soft cloth. In the case of speeding up
the process of defrosting,you may put a bowl of warm water (about 50℃) into the freezer chamber,
and scrape away the ice and rost with a defrosting spatula. After doing so, be sure to set the knob
of the temperature regulator to the original position.It is not advisable to heat the freezer chamber
directly with hot water or hair dryer while defrosting to avoid deformation of the inner case.It is also
not advisable to scrape off ice and frost or separate food from the containers which have been
congealed together with the food with sharp tools or wooden bars, so as not to damage the inner
casing or the surface of the evaporator.
IMPORTANT! – in order to make the most of the volume of the fresh food compartment and
frozen-food storage compartment, the user can removedshelves, drawers, out of the appliance,
according to your daily use.
Defrosting Why defrosting
Water contained in food or getting into air inside the fridge be opening doors may form a layer pf
frost inside.It will weaken the refrigeration when the frost is thick. While it is more than 10mm thick,
you should defrost.
Defrosting in fresh food storage compartment
It is automatically controlled by switching the temperature regulator on or off so that there is no
need of operation of defrosting. Water from defrosting will be drained into an drip tray through a
drain pipe at the back of the fridge automatically.
16

Warning!
Switching off the appliance.
To switch off the appliance, turn the temperature regulator to position ”0”.
Important!
The fridge should be defrosted at least every one month. During the using process, if the door
was opened frequently or using the appliance in the extreme humidity, we advise the user to
defrost every two weeks .
17

1.5
18

19