BAVARIAN SIMTEC OmegaPRO User manual

Owners Manual
ΩPRO

Mount a Quick Release
Mount your desired Quick Release to Adapterplate
Choose between the 70mm or 50.8mm bolt pattern
50.8mm
70mm
Choose between threaded and none threaded holes
Mount the Adapterplate together with your quick
release on to the Omega Steering Wheel with the
supplied M5x12mm screws
M5 x 12mm
2
Mount your
Quick Release
on this side
M5 Threaded Holes

For smooth operation, we recommend using
one of the following connection methods:
Steering Wheel Conection
Align pins via connector alignment key
BSTec Coiled Cable -> Powered USB Hub -> PC
BSTec Coiled Cable -> Active USB Repeater -> PC
To ensure proper operation, you need to have a clean, reliable USB data
throughput signal and the absence of EMI (Electrical Magnetic Interference) from
- Connect wheel via a powered USB hub or directly to computer.
- Avoid excessively long USB extension cables. Data degrades on longer USB extensions.
- Please update AMD systems with poor USB performance to AGESA bios 1.2.0.2 or higher.
- Check for EMI (Electrical Magnetic Interference) and ground rig if needed.
- Try alternate USB ports if one port is not performing to spec.
- Check coiled cable to make sure cable housing is screwed on tight.
- USB shares data throughput with all devices on the system. Make sure you are not overloading the USB tree.
- Use a dedicated PCIE USB card. (We recommend NEC chipset cards)
3

Setup SimHub
4
1 & install the latest SimHub version
(v8.4.9 or greater)
Download
https://www.simhubdash.com/download-2/
1. Go to Devices Tab
2. Click Add Device
Add Device 1
2

5
3. Select BavarianSimTec in the side panel
4. Select the OmegaPRO
5. Click Ok
Select OmegaPRO
34
5

6
6. Simplified Profile
In this profile the LED’s are grouped logically
per button and encoder.
7. Advanced Profile
In this profile every LED can be individual
addressed allowing you full control over all
87 LED’s. This option is usually requiered for
custom LED profiles
Choose Profile
3
67

7
8. Select LCD
9. In the dropdown Display dashboard select
the BavarianSimTec OmegaPRO
Dashboard
8
9
the official OmegaPRO Dash
(double click downloaded file to install)
Download
https://download.bavariansimtec.com/BavarianSimTec_Dashboard_OmegaPRO.simhubdash

8
10. Select LEDs
11. Click Edit Default colors to change the
button colors
LED’s
10
11

9
Enter/Exit EditMode
1 2
Press and hold , encoders for 3 seconds.
The dash will change to edit mode.
Exit the Edit Mode with
1 2
Calibrate Clutch
Press and hold button (left) (right), pull
the clutch completely and release the clutch.
Then release the button.
3
4
3 4
56
Cycle Clutch Modes
With the buttons and
you change the clutch mode.
5 6
Bite Point
Change Bite Point save
position with
+/- 10%
+/- 1%
789
8
7
9
10
11
12
13 14
15
Master Clutch
Change the Master
Clutch with 10 11
Grayhill Mode
Change the Grayhill
Mode 12 13 14 15
16
16