Bazooka BPB24-G2 User manual

Volume down --
Song reversP- -
Play/ Pause / Mute --
Accessory --
1.Long-press the Mode button to turn
the Party Bar ON/OFF.
2.Click-press LED to turn on/off beat
to music mode.
3.Long-press the LED button to turn
the LED lightsOn/Off.Then, click
press the LED button to cycle
through stored LED sequences.
4.ACC button turns ON/OFF the
accessory 12v pig tail for an external
LED light bar or other accessory.
Volume up
Song forward
Mode
(Change Music Mode)
LED
5.Click-press the Mode button to
toggle between Bluetooth/ Aux/USB
listening modes.
6.Press >II to Pause/Play/mute music.
7. Press Vol+/- to raise and lower the
volume of the Party Bar.
8.Press I<< and >>I buttons to track
forward/reverse on songs.
n~tilll~d Instructions CilnIJ~ found ilt WWII' hilZOOkil.COm
UnllltJSh thll Sound tJndlllumlntJtll Your Rdllllnturll

PartyButton:Click- Press cycles through the
below modes.
Blue:Single Listener Mode
Purple: DJ Broadcast Mode
Red:DJListening Mode (rejoins previous
"Party" if available).
SETTING UP A PARTY: - - - - - -•
ODecide who will DJ the Party and who
will Listen
@ DJ: Click the Party button on the
designated DJ bar until it turns PURPLE and
then long-press the Party button to enter
"Broadcast Pairing" mode (Party button will
blink while in Broadcast Pairing mode.
Multiple Listener bars can join
simultaneously while the DJ bar is in
Broadcast Pairing mode and the Party
Button is still blinking.)
@Listeners: Click the Party Button on the
Listener bar unt il it turns RED and then
long-press the Party button to enter
"Broadcast Pairing" mode.
OThe bars will automatically sync and all
Listener bars will yield musicand LED
lighting control to the DJ bar.
0Repeat steps above for any NEW
"Listener" that wants to join an ongoing
party .Only the DJ will need to enter
Broadcast Pairing mode while a Party is in
progress to allow the Listener to join. All
other Listeners will remain in the Party
while the new Listenerjoins.
Listeners can leave an existing Party by
switching to Single Listener Mode , as well
as rejoin the Party by switching back to DJ
Listening Mode.
Listeners can control the local volume on
their bar using the Vol +/- buttons or mute
their bar by clicking the Play/Pause(= /> )
button . However, anytime the DJ adjusts
the volume of the DJ bar it will reset all
Listener bars to the current volume of the
DJ bar.
All G3 Party Bars remember their last Party.
Once a Party has been established it can
easily be recreated provided the original DJ
bar is going to be the DJ again. To recreate
the last Party simply turn the bars ON and
click the Party Button on each bar to put
that respective bar back into DJ Broadcast
or DJ Listening mode.The last Party will
automatically be recreated provided the
original DJ bar is present and turned ON in
DJ Broadcast Mode .

BPB24-G2 BPB24-DS-G2
BPB36-G2
Remote Pairing Instructions
Step 1. Remove the power from the BPB-G2 by unplugging
the main power cable.Wait 30 seconds
Red LED
Step 3. Plug the BPB-G2’s main power cable back in.
You will see the flashing LED on the remote go off.
Now your remote is paired to the BPB-G2.
HoldHold
Step 2. Press and hold the 1and 4buttons.
After 5 seconds you will see that the red led
on the remote will start to flash slowly. Once
the led is flashing release the buttons.