SETTING UP A PARTY:
Decide who will DJ the Party and who
will Listen
DJ: Click the Party button on the
designated DJ bar until it turns PURPLE and
then long-press the Party button to enter
“Broadcast Pairing”mode (Party button will
blink while in Broadcast Pairing mode.
Multiple Listener bars can join
simultaneously while the DJ bar is in
Broadcast Pairing mode and the Party
Button is still blinking.)
Listeners: Click the Party Button on the
Listener bar until it turns RED and then
long-press the Party button to enter
“Broadcast Pairing" mode.
The bars will automatically sync and all
Listener bars will yield music and LED
lighting control to the DJ bar.
Repeat steps above for any NEW
“Listener” that wants to join an ongoing
party. Only the DJ will need to enter
Broadcast Pairing mode while a Party is in
progress to allow the Listener to join. All
other Listeners will remain in the Party
while the new Listener joins.
Listeners can leave an existing Party by
switching to Single Listener Mode, as well
as rejoin the Party by switching back to DJ
Listening Mode.
Listeners can control the local volume on
their bar using the Vol +/- buttons or mute
their bar by clicking the Play/Pause (=/>)
button. However, anytime the DJ adjusts
the volume of the DJ bar it will reset all
Listener bars to the current volume of the
DJ bar.
All G3 Party Bars remember their last Party.
Once a Party has been established it can
easily be recreated provided the original DJ
bar is going to be the DJ again. To recreate
the last Party simply turn the bars ON and
click the Party Button on each bar to put
that respective bar back into DJ Broadcast
or DJ Listening mode. The last Party will
automatically be recreated provided the
original DJ bar is present and turned ON in
DJ Broadcast Mode.
Party Button: Click-Press cycles through the
below modes.
Blue: Single Listener Mode
Purple: DJ Broadcast Mode
Red: DJ Listening Mode (rejoins previous
“Party” if available). DJ
Broadcast
Mode
DJ
Listening
Mode
Single
Listening
Mode
