BCI ARMADILLO L-SCREEN User manual

[phone] | [email protected]om 1
ARMADILLO L-SCREEN
ASSEMBLY INSTRUCTIONS
ABOUT THE L-SCREEN
The Armadillo L-Screen can be used for protecting a pitcher or pitching ma-
chine. This L-Screen has 2”OD poles and a #60 HDPE sock net. To provide extra
protection against ricochets there is padding attached to the middle of the
L-Screen.
NOTE: Armadillo shown with OPTIONAL wheel kit attached.

[phone] | [email protected]om
ARMADILLO L-SCREEN
ASSEMBLY INSTRUCTIONS
2
BEFORE YOU BEGIN
Read these instructions fully before starting the assembly
process. Please make sure you have all of your parts and
pieces. If not, contact our customer service.
1)
30 5/8”
4 ea 2)
37 1/4”
1 ea
3)
39 3/8”
1 ea 4)
41”
1 ea
5)
23 1/2”
1 ea 6)
17 1/2”
1 ea
7)
42”
1 ea 8)
18 1/16”
1 ea
9)
19 9/16”
2 ea 10)
32 1/2”
1 ea
(1) 7x7 #60 HDPE L-Screen Net
(1) Corner pad
(1) Straight pad
(1) Armadillo frame kit (shown below)
(2) Transport wheels (if purchased)
What’s Included
Corner Pad Straight Pad

[phone] | [email protected]om
ARMADILLO L-SCREEN
ASSEMBLY INSTRUCTIONS
3
7
10
3
2
1
6
4
1
1
1
5
9
9
8
8
8
8Long Side Short Side

[phone] | [email protected]om
ARMADILLO L-SCREEN
ASSEMBLY INSTRUCTIONS
4
1) Assemble Supporting Legs
Start by assembling the bottom of the
L-Screen. Bolt together the supporting legs
with poles 8 and 9.
2) Finish Assembling the Base
Assemble the other supporting leg and connect
them with poles 1 and 5 to create the base.
3) Assemble Vertical Sections
Assemble the vertical sections separately from the
base using poles 1, 2, 3, 4, 6, and 10.
4) Connect Vertical Section to the Base
Place the vertical section of the L-Screen into the
base as shown below. Tighten the bolts.

[phone] | [email protected]om
ARMADILLO L-SCREEN
ASSEMBLY INSTRUCTIONS
5
5) Attach Last Pole
Connect pole 7 to the top of the screen
and bolt together.
6) Put on Net & Tighten Bolts
Lastly, slide the sock net over the top of the frame
like a pillowcase. Check all bolts and tighten as
needed.
7) Zip Tie Pads to Frame
Wrap the straight pad on top of the horizontal pole.
Using the provided zip ties you will insert them
both grommets across from each other. Wrap the
corner pad around the vertical and horizontal poles
and insert the zip through both grommets.
8) Attach Wheel Kit (If Purchased)
If purchased attach the two wheels to one side of
the bottom supporting legs of the L-Screen.