
Pg. 3
Reason
Not properly plugged in
Blown fuse/tripped circuit breaker
Timer not on
Drain hose twisted or still
clipped to machine
Load too heavy
Problem
Not Washing/Spinning
Not Draining
Weak Wash Cycle
Solution
Make sure device is properly plugged in
Replace fuse/reset circuit breaker
Turn timer to your desired wash/spin time
Unhook and straighten hose
Remove laundry
•Wipe machine with a damp cloth to remove dirt. If necessary, use a mild detergent.
•Store machine in a cool, dry place.
OPERATING INSTRUCTIONS
CLEANING AND STORAGE
TROUBLESHOOTING
WASHING:
1. Place the washing machine on a level surface near a drainage point.
2. Open the lid and turn the spin basket clockwise to remove it.
NOTE: Make sure that the water drainage tube is clipped to the right side of the machine.
3. Place laundry in the washing machine. Plug the machine into a wall outlet.
4. Fill the basin with warm water via the water inlet tube or directly into the basin with a bucket.
Do not exceed the max fill line.
NOTE: It is recommended not to use water exceeding 104°F.
5. Add laundry detergent to the basin. Select the wash function. Turn the timer to your desired
wash time.
6. When the wash cycle finishes, unhook the drainage tube and drain the water into a drainage
point or a suitable container.
RINSING:
1. Clip the water drainage tube to the right side of the machine.
2. Fill the basin with clean water via the water inlet tube or directly into the basin with a bucket.
Do not exceed the max fill line.
3. Turn the timer to your desired wash time.
4. When the wash cycle finishes, unhook the drainage tube and drain the water into a drainage
point or a suitable container.
5. Repeat until the laundry has been thoroughly rinsed.
SPIN CYCLE:
1. Open the lid and install the spin basket.
2. Place wet laundry into the spin basket. Do not to overload the basket.
3. Select the spin function. Turn the timer to your desired spin time.
4. When the spin cycle finishes, remove your laundry.
5. Repeat if necessary.