Beat-Sonic FDA51 Series User manual

M5 Screw Alcohol
Cleaner
Double-Sided Tape
Antenna Cable
Joining Terminal
Shark-n Antenna Unit
Contents
Specication
Reception Frequency: FM (76.0MHz - 108.00MHz) AM (530KHz - 1,710KHz)
Antenna Form: Helical Antenna
Installation Method: Joining terminal to base of factory antenna
Unit Dimensions (mm):
Attachment Method: Using 3M double-sided tape
Screw Type: Screw
User’s Manual
Thank you for purchasing Beat-Sonic USA Shark Fin AM/FM Antenna FDA51 Series.
Please read carefully and follow these instructions before installing this product.
Features
Allows shark-n antennas on vehicles originally equipped with pole antennas.
Helical antenna wire to ensure maximum radio signal.
Easy installation using provided double sided tape.
Rubber lining ensures compability to many applications to match vehicle’s roof curve.
Not having to worry about the eect car washes and low ceiling garages have on the antenna.
Adds a luxury and sophisticated look to your vehicle.
Please take the following precautions during installation and operation of this antenna to
precent accidents resulting in injury or death by re or electrical shock.
- This antenna is only compatible for AM/FM signals.
- The joining terminal is to be connected to the base of the factory antenna only.
- Do not disassemble or alter the antenna. This will also void warranty.
For Safe Operation
Beat-Sonic USA
14778 Beach Blvd. La Mirada, CA 90638
Tel: [phone] Fax: [phone]
URL: htt://www.beatsonicusa.com E-mail: inf[email protected]

Shark-Fin Radio Antenna Installation Instructions
Remove the OEM pole antenna.
The OEM pole antenna is easily removed by unscrewing
counter-clockwise from the antenna base.
Caution: Clean all the dust or rust around the antenna’s
screw hole after dismounting the OEM pole antenna.
Antenna base
Antenna pole
The cable terminal of the shark-n radio antenna is installed on the base.
The joining terminal is connected from the shark-n antenna with a metal screw to the base.
Screw
Screw
Screw connecting location
Caution:
Please conrm electric
connection before
the antenna is fastened to the
roof
Remove double sided tape
The shark-n radio antenna is secured over the factory antenna base.
Use masking tape around the installation area.
Wipe the installation area using alcohol wipe.
Clean the area around the antenna base
Using the included alcohol wipe, clean the area around the antenna base thoroughly.
*Place the masking tape before using the alcohol wipe.
After conrming location to secure the antenna, remove the double sided tape cover to expose
the adhesive side and secure over the antenna base and on the roof.
Press and hold for 1 minute to ensure maximum contact.