Mercury CAUHF-P14 User manual

CAUHF-P14
EASY INSTALL 36 ELEMENTS
UHF AERIAL
Item ref: 130.011UK
User Manual
○
A–Triple boom main body
○
B–Dipole box
○
C–Reflectors
○
D–Pole mast
SPECIFICATION:
Frequency Range
470 –862MHz
Channels
21 - 69
Gain
9 –14dB
Beam Width H/V
H:40° / V:55°
Front to Back Ratio
16dB
Impedence
75Ω
Fully Opened Dimension
680 x 500 x 940(antenna length) mm
CAUHF-P14

INTRODUCTION:
Thank you for choosing Mercury antenna. This antenna has an easy install design which allows tool free
quick installation. The simple pull and fasten design make this product ideal for both DIY and professional
installation. Please follow the steps below for assembly.
Step 1:
Pull the upper and lower beam on the main body outward fully until they are fully opened and fasten
wing nut to the lock in position.
Step 2:
Slide the screw on the dipole box through the main body of the antenna as below, secure the box by
tighten the wing nut.

Step 3:
Rotate the elements until they sit into the pre-cut slot in position. Tighten the 3 wing nuts on the reflector
to ensure the elements are tight in place.
Step 4:
Position the reflector housing, reflector and main body as picture below, guide the 3 screws through the
pre drilled holes and fasten the wing nuts on to the screws to ensure reflectors are secured on the main
body.

Step 5:
Loosen the mast clamp until the mast pole can fit through it, ensure the tip of the antenna is facing
directly toward the signal transmitter you wish to receive on and tighten up the wing nuts until the aerial
is securely mounted on the mast pole. Loosen adjustment nuts and adjust the aerial closest to horizontal
level and tighten it again to lock it in position.
Please note, for best reception. Position antenna at the highest possible location, as blockage in line of
sight between antenna and transmission tower may cause signal loss, having the antenna installed at
highest possible location will minimize the chance of signal blockage.
The design of triple boom antenna reception is directional, this allows the antenna to receive signals that
come from a forward direction only and minimise the noise pick up from all other surrounding directions.
Therefore when positioning the antenna please ensure the tip of the antenna is pointing directly to the
signal transmission tower that you wish to receive on.
This product is classed as Electrical or Electronic equipment and should not be disposed
with other household or commercial waste at the end of its useful life. The goods must be disposed of
according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd