CommScope CMAX-DMF4-43-Wi53 User manual

Installation Instruction for CMAX Antennas
Page 1 M0153A6A_InstInstr_CMAX-DMF4-43-Wi53
Installation Guide for
CMAX-DMF4-43-Wi53 Antenna
Note: Please read the complete description before starting the installation. Make sure
that connectors are properly sealed against water if no cables are connected to
them after installation.
1.Assembly
Fit these seven parts above together and fasten them with screws M6, nuts M6, spring
washers, and washers.

Installation Instruction for CMAX Antennas
Page 2 M0153A6A_InstInstr_CMAX-DMF4-43-Wi53
2.Wall Mounting
1. Use this pedestal piece as a drill jig to mark 4 holes onto the wall as shown in the drawing
above.
2. Drill 4 holes into the wall and insert 4 expansion bolts into the holes.
3. Install the mounting kits to the expansion bolts and tighten the M6 nuts and flat washers.
4. Attach the antenna to the mounting kits and then tighten the M4 nuts, spring washers and
flat washers...
Note:
Cable min. bending radius: 40mm

Installation Instruction for CMAX Antennas
Page 3 M0153A6A_InstInstr_CMAX-DMF4-43-Wi53
3.Pole Mounting (28~60 mm pole diameter)
4. Antenna Mounting
4.1. Antenna Mounting
M6 nut
Washer
28~60 mm
Spring Washer

Installation Instruction for CMAX Antennas
Page 4 M0153A6A_InstInstr_CMAX-DMF4-43-Wi53
4.2. Azimuth Angle
1. Loosen the fixing screws. (D o NOT
unscrew them completely.)
2. Adjust your desired angle. The
complete antenna pedestal can be
swiveled to the lef t- / right-hand side
by up to 60°.
3. Tighten the f ixing screws.
4.3. Elevation Angle
1. Loosen the f ixing screws. (Do
NOT unscrew them completely.)
2. Adjust your desired angle. The
complete antenna pedestal can
be swiveled to the top / bottomby
up to 40°.
3. Fasten the fixing screws.

Installation Instruction for CMAX Antennas
Page 5
Technical Support:
http://www.commscope.com/wisupport M0153A6A_InstInstr_CMAX-DMF4-43-Wi53
4.4. Outdoor Installation
Note: For outdoor use, we recommend removing the plugs from the drain holes if the
antenna is exposed to high humidity or rainfall.
: Do not remove the plugs if the antenna is mounted other than bottom down,
that means the drain holes showing to the ground. For the top and bottom of the antenna
observe the arrow labeling at the rear side. Otherwise water might penetrate into and
therefore damage the antenna.
Remove the plugs from the drain holes at the bottom of the antenna with a knife or a flat
screwdriver. The below indicates the location of the drain holes, design and/or size of the
antenna may be different.
© Copyright 2020 CommScope, Inc.
All rights reserved.
All information contained in this manual has been revised thoroughly. Yet CommScope accepts no liability forany omissions or faults.
CommScope reserves the right to change all hardware and software characteristics without notice.
Names of products mentioned herein are used foridentification purposes only and may be trademarks and / orregistered trademarks of
their respective companies.
No parts of this publication may be reproduced, stored in a retrieval system, transmitted in any form or by any means, electronical,
mechanical photocopying, recording or otherwise, without priorwritten permission of the publisher.
CommScope, 07-May-2020
Bottom
Bottom