Beds By George Haven Bed User manual

Beds By George, Inc ®
Haven Bed
Assembly Instructions
Model _________
Serial Number _________________
All beds have either casters or adjustable feet.
Attach whichever is provided to bottom of
corner posts.
1
or
Updated 10-5-16

Attach aluminum poles to top of
corner posts
Attach wood sides to
corner posts using flat head
1 1/4 bolts.
DO NOT
TIGHTEN until
metal poles in
place
Slide cast aluminum
brackets onto poles. Do
NOT tighten set screws
yet.
Install poles into brackets
Tighten flat head bolts
Install top corner brackets as shown.
Install remaining pipe into brackets
Do NOT tighten set screws yet
Outside View
Inside View
23
4
1
1

After rolling fabric until
snug, tighten set screws
Canopy fabric
Velcro
Roll pipe TOWARDS
YOU as shown. Velcro
will be rolled inside fab-
ric
Remove adhesive
loop side of Velcro
from the top flaps of
the fabric. Attach to
top horizontal poles.
Attach top fabric
flaps to Velcro on
pipes as shown.
Three sides installed, ready for the last side
NOTE THE DIRECTION THE FABRIC SHOULD ROLL
6

Roll pipe AWAY
FROM YOU as
shown. Velcro will
be rolled inside
fabric
Remove adhesive
loop side of Velcro
from the bottom flaps
of the fabric. Attach
to top horizontal
poles.
Attach top fabric
flaps to Velcro on
pipes as shown.
After rolling fabric until
snug, tighten set screws
Unzip door
On the corners there are
two flaps, a long and a
short.
Wrap short flap around
pole and hold in place.
Wrap longer flap the
other way around pole
and attach to Velcro
sewn to canopy.
Re-zip the door ensuring
the fabric is taut but not
to the point that the
zipper won’t close.
8
7

Attach vertical wood
shroud to corner posts
with flat head bolts
Attach top pieces of wood shroud using flat head bolts
Bed assembly complete
Final step, install the mattress
910
11

Accessory:
IV Pole
George’s Helpful Hints:
 Bracket with half circle goes on bottom
 COMPLETE
No less than 2”
11” to 20” apart
If bed comes with IV poles, install brackets
as shown to vertical shroud Closing notes:
While the fabric does not stretch, it will relax or shift over
time. We recommend the sides are tightened as needed by
releasing the set screw and rolling the fabric until the side
becomes taut again, then retighten the set screw.
It may be necessary to remove top wood shroud for
tightening.
Failure in keeping the fabric taut,
overtightening the fabric or the set
screw can result in poor performance
or damage to the bed.