Operating the dishwasher
How to cancel the washing programme
To cancel a programme while the machine is operating:
·Open the door.
! Care must be taken when opening the door, as steam will escape.
·Press and hold start/stop button for 3 seconds. The start / stop indicator light will start flashing. Close the
door. The machine will drain the water inside the machine for 45 seconds.
·The programme is cancelled when start/stop indicator light goes off. Then, you can choose and start a new
programme.
!Depending on the stage of the programme you have cancelled, there may be detergent residue or rinse aid
inside the machine and on the load. Make sure the items in the dishwasher are not used before washing properly.
To change the programme selection while the machine is operating:
·Open the door.
! Care must be taken when opening the door, as steam will escape.
·Press start/stop button. The indicator light will go off.
·Select the new programme. Press start/stop button. The indicator light will be on and new programme will
start.
!The new programme will NOT start right from the beginning. It will start from the stage last carried out
by the previous programme selection.
How to change the washing programme
·Push in the on/off button and check that the programme indicator lights come on.
·Check the salt and rinse aid level indicator lights before you start the machine. If necessary add salt and rinse
aid.
·Select the required programme by referring to the programme chart.
·Select the desired programme by using the Programme Selection Button.
·Press start / stop button.
·
Close the door then programme starts.
·An audio signal with an interval of 10 seconds warns you to switch your machine off when the selected
washing programme ends. This audio signal warns you for a duration of 1 minutes and then turns off.
!Do not open the dishwasher door whilst the appliance is in operation. However, in case the door is opened
while the machine is working, then a safety mechanism ensures the machine immediately stops. Water may be
very hot, so be careful.
·
Care must be taken if opening the door, as steam and water will escape.
·Press the on/off button after the programme is completed. The indicator lights will go off.
·Unload the baskets - we recommend to turn off the water tap when not in use.
Printed in Turkey Part no: 17 9485 0100-AA
Beko plc, Beko House, Ca ton Way, Watford, Hertfordshire, WD18 8UF
Half Load
Select Half Load when using any wash programme [E cept Prewash] to save on water, electricity and time if the
machine is only half full. You can place dishes anywhere in the machine; some upper and some lower basket.