
5/EN
Electrical safety
• If the product has a failure, it
should not be operated
unless it is repaired by an
Authorised Service Agent.
There is the risk of electric
shock!
• Only connect the product to
a grounded outlet/line with
the voltage and protection as
specified in the “Technical
specifications”. Have the
grounding installation made
by a qualified electrician while
using the product with or
without a transformer. Our
company shall not be liable
for any problems arising due
to the product not being
earthed in accordance with
the local regulations.
• Never wash the product by
spreading or pouring water
onto it! There is the risk of
electric shock!
• Never touch the plug with
wet hands! Never unplug by
pulling on the cable, always
pull out by holding the plug.
• The product must be
disconnected during
installation, maintenance,
cleaning and repairing
procedures.
• If the power connection cable
for the product is damaged, it
must be replaced by the
manufacturer, its service
agent or similarly qualified
persons in order to avoid a
hazard.
• The appliance must be
installed so that it can be
completely disconnected
from the mains supply. The
separation must be provided
by a switch built into the fixed
electrical installation,
according to construction
regulations.
• Rear surface of the oven gets
hot when it is in use. Make
sure that the electrical
connection does not contact
with the rear surface;
otherwise, connections can
get damaged.
• Do not trap the mains cable
between the oven door and
frame and do not route it
over hot surfaces. Otherwise,
cable insulation may melt and
cause fire as a result of short
circuit.
• Any work on electrical
equipment and systems
should only be carried out by
authorised and qualified
persons.