
9 / 26 EN
Refrigerator/User Manual
3Installation
3.1. Appropriate
Installation Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
B
WARNING: Manufacturer
shall not be held lable for
damages that may arse from
procedures carred out by
unauthorzed persons.
B
WARNING: Product must
not be plugged n durng
nstallaton. Otherwse, there
s the rsk of death or serous
njury!
A
WARNING:
If the door clearance of the
room where the product shall
be place s so tght to prevent
passng of the product, remove
the door of the room and pass
the product through the door
by turnng t to ts sde; f ths
does not work, contact the
authorzed servce.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm
away from heat sources such as hobs,
heater cores and stoves and at least 5
cm away from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
• Your product requres adequate ar
crculaton to functon effcently.
If the product wll be placed n an
alcove, remember to leave at least 5
cm clearance between the product
and the celng, rear wall and the sde
walls.
• If the product wll be placed n an
alcove, remember to leave at least 5
cm clearance between the product
and the celng, rear wall and the
sde walls. Check f the rear wall
clearance protecton component s
present at ts locaton (f provded
wth the product). If the component
s not avalable, or f t s lost or fallen,
poston the product so that at least
5 cm clearance shall be left between
the rear surface of the product and
the wall of the room. The clearance
at the rear s mportant for effcent
operaton of the product.