BEMMA ZANZI 30 User manual

P.9-11
ASSEMBLY INSTRUCTIONS
ZANZI ASSEMBLY INSTRUCTIONS
Designer Vanities & Accessories

BEFORE
You Begin
1. Tools and materials needed:
2. Product dimensions:
3. Damaged product: DO NOT USE if product and/or components
are broken
4. For installation of faucet and plumbing, we recommend the use
of a licensed plumber. Ensure all building & plumbing codes are
respected
5. Assembly should be done with two adults
ASSEMBLY INSTRUCTIONS
Marker Drill Phillips
Screwdriver
Tape
Measure
Stud
Finder Level

STEP 1
Secure Vanity to Wall
1. Place the vanity in the desired location
2. Using the stud finder and marker, locate and mark the studs
behind the wall
Important: if the studs do not line up for your vanity, wood blocking
can be installed between studs
3. Ensure the vanity is level. Adjust floor levelers at bottom of foot
Note: adjustments are sometimes needed due to uneven flooring
4. Secure the vanity to the wall using wood screws (not provided)
Locate wall studs and
use this rail to secure
vanity to the wall
ASSEMBLY INSTRUCTIONS

STEP 2
Install the Backsplash (if desired)
1. Ensure vanity base is in its location and all plumbing is in place
2. Apply a bead of silicone to the top edge of vanity base.
Important: Backsplash and countertop is very fragile, assembly
must be done with two people.
3. Fill in any gaps with silicone sealant
4. Wipe away any excess silicone immediately
5. Allow silicone sealant to fully dry for 24 hours
24 hr
Stone Sealer
ASSEMBLY INSTRUCTIONS

STEP 3
Adjust the Hinges & Glides (if required)
2. If vanity drawers are misaligned, adjust glides
Side adjustment Depth adjustment
ASSEMBLY INSTRUCTIONS
1. If vanity doors are misaligned, adjust hinges
Height adjustment

STEP 4
Removing Drawer (if required)
1. Pull drawer towards you until it has reached full extension away
from the cabinet
2. Under the drawer, locate the pair of green tabs with pins located
at the front of the slide
3. Carefully push the tabs towards each other to unlock the slides
4. Remove the drawer box from the slide by lifting up and out while
holding the tabs in the “unlock” position
Remove drawer box
from slide by lifting up
and out
ASSEMBLY INSTRUCTIONS
Carefully push the tabs
towards each other to
unlock the slides

STEP 5
Inserting Drawer (if required)
1. Pull drawer glides all the way out
2. Locate the hole at the back of the drawer box
3. Insert the hole into the peg located at the back of the slide
and slowly place the drawer box onto the extended slides
4. Hold the lock tabs towards each other while pushing inwards to
lock in place
5. Ensure the drawer guide is fitted well into the lock
6. Adjust the slides as seen in step 3
ASSEMBLY INSTRUCTIONS
Hold the lock tabs
towards each other
while pushing inwards
to lock in place

ZANZI
Product Details
CARE AND CLEANING
For stone tops such as marble and granite, it is recommended that you apply a high-
quality sealer to protect from staining and discoloration. Stone sealer should be
reapplied once or twice per year, depending on usage.
After each use, simply wipe with a soft cloth to remove any surface dirt.
For standard cleaning, we recommend using warm water with vinegar.
DO NOT USE abrasive products or cream cleansers.
NEVER USE petroleum-based products when cleaning, i.e. paint thinners or other
solvents, as they may damage the wood
THANK YOU FOR YOUR BEMMA PURCHASE
ASSEMBLY INSTRUCTIONS