Bergman Pro 318 4277 User manual

Wet and Dry Vacuum
318 4277
Instruction Manual
Please retain this manual for future reference

1
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
1
1
2
8
3
6
7
13
17

2
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
5
6
7
13
2
13
10
15
16
14
12
11
4
3
9
4
5
3
1
3
1
18

3
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
7
8
15
10
9
10a
10
11
10b
10c
11
12
11
16
14
8

4
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
Important!
When using equipment, a few safety precautions must be observed to avoid injuries and
damage. Please read the complete operating manual with due care. Keep this manual in a
safe place, so that the information is available at all times. If you give the equipment to any
other person, give them these operating instructions as well.
We accept no liability for damage or accidents which arise due to non-observance of these
instructions and the safety information.
1. Safety information
Important: Read the operating instructions before assembling and using the appliance
for the first time.
Check that the mains voltage is the same as the mains voltage specified on the rating
plate.
Only connect the appliance to a properly fitted 220-240V~, 50/60 Hz shock-proof socket.
Pull out the power plug in the following circumstances: Whenever the appliance is not in
use, before opening the appliance and before all cleaning and maintenance work.
Never clean the appliance with solvents.
Never pull the plug out of the socket by pulling the cable.
Never leave the appliance unattended when operational.
Keep away from children.
Take care to ensure that the power cable does not get damaged by being run over,
crushed, pulled or suchlike.
Do not use the machine if the power cable is in a less than perfect condition.
If the power cable has to be replaced, the replacement must comply with the design
specifications of the manufacturer. Power cable: H 05 VV - F 2 x 0.75 mm2
If the supply cord is damaged,it must be replaced by the manufacturer,its service agent
or similarly qualified persons in order to avoid a hazard.
Never vacuum the following: Burning matches, smoldering ash and cigarette butts,
combustible, caustic, inflammable or explosive substances, vapor or liquids.
This appliance is not suitable for vacuuming dust which can be harmful to health.
Store the appliance in a dry indoor location.
Never use the appliance if it is damaged.
Only allow the appliance to be serviced by an authorized after sales service outlet.
Only use the appliance to carry out work for which has been designed.
Take extra care when cleaning steps.
Use only genuine accessories and spare parts.
The power plug must be removed from the power socket when not in use, before
cleaning or servicing.
This appliance can be used by children aged from 8 years and above, and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be performed by children without supervision.

5
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
2. Layout and items supplied (Fig. 1, 2, 4)
1. Handle
2. ON/OFF switch
3. Head
4. Filter cage
5. Safety float valve
6. Locking hook
7. Tank
8. Suction hose connection
9. Blow connector
10. Flexible suction hose
11. 3-part suction tube
12. Combination nozzle
13. Wheels
14. Cloth filter
15. Foam filter
16. Crevice nozzle
17. Water drain screw
18. Fixing screws (2pcs)
3. Intended use
The wet and dry vacuum cleaner is designed for wet and dry vacuuming using the
appropriate filter. ATTENTION! The appliance is not suitable for the vacuuming of
combustible, explosive or harmful substances.
The machine is to be used only for its prescribed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the manufacturer will be liable for any damage
or injuries of any kind caused as a result of this.
Please note that our equipment has not been designed for use in commercial, trade or
industrial applications. Our warranty will be voided if the machine is used in commercial,
trade or industrial businesses or for equivalent purposes.
4. Technical data
Mains voltage: 220-240V~ 50 Hz
Model(s)
Power input
Tank volume
Net weight
MWW706-20L-1300WA
318 4277
1300W
20 L
4.80Kgs
5. Before starting
Important!
Before you connect the appliance to the mains supply make sure that the data on the
rating plate are identical to the mains data.
The appliance may only be connected to a shockproof socket.

6
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
5.1 Appliance assembly
Fitting the handle (Fig. 3)
Fix the handle (1) by two screws supplied.
Fitting the appliance head (Fig. 5)
The appliance head (3) is fastened to the container (7) by the locking hook (6). To remove
the appliance head (3), open the locking hook (6) and remove the appliance head (3). When
fitting the appliance head (3), make sure that the locking hook (6) locks into place correctly.
Assembling the wheels (Fig. 6)
Fit the wheels (13) in accordance with fig. 6.
5.2 Fitting the filter
Important!
Never use the wet and dry vacuum cleaner without a filter.
Check that the filter is securely fitted at all times.
Fitting the cloth filter (Fig. 7)
For dry vacuuming, slip the cloth filter (14) over the filter cage. The cloth filter (14) is suitable
for dry-vacuuming only.
Fitting the foam filter (Fig. 8)
For wet vacuuming, slip the supplied foam filter (15) over the filter cage (Fig. 4/4).
5.3 Fitting the suction hose (Fig. 4, 9, 10)
Connect the suction hose (10) to the corresponding connector on the wet and dry vacuum
cleaner, depending on the application required.
Vacuuming
Connect the suction hose (10) to the suction hose connector (8).
Blowing
Connect the suction hose (10) to the blow connector (9).
The 3-part suction tube (11) can be attached to the suction hose (10) to extend it.
5.4 Suction nozzles
Combination nozzle (12)
The combination nozzle (12) with attachments is for vacuuming solids and liquids over
medium to large areas. The crevice nozzle (16) is specially designed for cleaning cervices
and edges.

7
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
6. Operation
Important!
Switch off the equipment if liquid or foam is emitted with the exhaust air when wet vacuum
cleaning.
6.1 On/Off switch (Fig. 1)
Switch position 0: Off
Switch position I: On
6.2 Dry vacuuming
Use the cloth filter (14) for dry vacuuming (see point 5.2).
Always ensure that the filters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam filter (15) (see point 5.2).
Check that the filter is securely fitted at all times.
Water drain screw (Fig. 1/17)
To make the tank (7) easier to empty after wet vacuuming, it is fitted with a water drain screw
(17). Open the water drain screw (17) by turning it anticlockwise and drain the liquid.
Important!
When wet vacuuming, the floating safety switch (5) closes when the maximum tank level is
reached. In doing so, the suction noise of the equipment will change and become louder.
You must then switch off the equipment and empty the tank.
Important!
The wet and dry vacuum cleaner is not suitable for the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam filter.
6.4 Blowing
Connect the suction hose (10) to the blow connector (9) on the wet and dry vacuum cleaner.

8
Scotts Ltd. Cotswold House, 1 Crompton Road, Groundwell, Wiltshire. SN25 5AW
Enquiries: 0344 482 9700
www.bergmantools.com
7. Cleaning, and maintenance
Important!
Always pull out the mains power plug before starting any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible.
We recommend that you clean the appliance immediately after you use it.
7.2 Cleaning the appliance head (3)
Clean the appliance regularly with a damp cloth and some soft soap. Do not use cleaning
agents or solvents; these may be aggressive to the plastic parts in the appliance.
7.3 Cleaning the container (7)
The container can be cleaned with a damp cloth and some soft soap or under running water,
depending on the amount of dirt.
7.4 Cleaning the cloth filter (14)
Clean the cloth filter (14) regularly by carefully patting it and cleaning it with a fine brush or
hand brush.
7.5 Cleaning the foam filter (15)
Clean the foam filter (15) with a little soft soap under running water and allow it to air-dry.
7.6 Maintenance
At regular intervals and before each use, check that the filters in the wet and dry vacuum
cleaner are securely fitted
8. Disposal and recycling
The crossed out Wheelie Bin logo is used to highlight electrical products that should not
be disposed of with normal household waste. Scotts Ltd has contributed to the funding
of an alternative network of UK recycling facilities.
Please visit www.recycle-more.co.uk to find where you’re nearest recycling point is and
recycle this product at the end of its life.
Made in China
For: