Berker 9490 01 00 Service manual

Antenna for radio receiver RMD
Order-No. : 9490 01 00
Operation- and
Assembly Instructions
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
The radio antenna including the antenna cable are not electrically isolated. Isolate the
antenna and antenna cable from mains voltage in a reliable manner using suitable
isolation measures.
To ensure adequate contact protection, operate device only with the slide in use.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
picture 1
(1) Antenna
(2) Magnetic base
(3) Antenna connector
3 Function
Intended use
The radio antenna supplements the integrated antenna of the radio receiver RMD in case of
unfavourable installation conditions, e.g. a metallic distribution box.
Seite 1/3
Antenna for radio receiver RMD
82553111
97-09582-000 30.07.2010
radio bus

4 Information for qualified electricians
4.1 Fitting and electrical connection
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before carrying out work on the device or load, disengage all the
corresponding circuit breakers. Cover up live parts in the working environment.
i To ensure optimal reception, place antenna on an electrically conductive surface;
50×50 cm is ideal. The antenna should be as close as possible to a 90° angle relative to
the surface.
Routing the antenna in front of the panel cover of the distributor
picture 2
o Insert the antenna connector (3) into the SMB socket (4) of the radio receiver RMD (5)
(picture 2).
o Route the antenna out of the distributor providing reliable isolation.
Seite 2/3 30.07.2010
82553111
97-09582-000
radio bus
Antenna for radio receiver RMD

Routing the antenna in behind the panel cover of the distributor
picture 3
o Unlock the black slide (6) by pulling up on the bow and pull out slide (picture 3).
o Insert the antenna connector (3) into the SMB socket (4) of the radio receiver RMD (5).
o Re-insert the black slide until it engages noticeably.
i The slide fixes the cable in place and ensures that the maximum installation height in the
distributor is maintained.
5 Appendix
5.1 Technical data
Antenna length 17 cm
Cable length 2.7 m
Connection SMB connector
5.2 Accessories
Radio receiver RMD Order-No. 9405 01 00
5.3 Warranty
We reserve the right to make technical and formal changes to the product in the interest of
technical progress.
Our products are under guarantee within the scope of the statutory provisions.
If you have a warranty claim, please contact the point of sale or ship the device postage free
with a description of the fault to the appropriate regional representative.
Berker GmbH & Co. KG
Klagebach 38
58579 Schalksmühle/Germany
Telefon + 49 (0) 2355/905-0
Telefax + 49 (0) 2355/905-111
www.berker.de
Seite 3/3 30.07.2010
82553111
97-09582-000
radio bus
Antenna for radio receiver RMD