Berkey Water View Spigot User manual

Stainless Steel
Berkey Water View™ Spigot
Cleaning & Assembly
Installation
Cleaning and Installation Instructions
Step 1
•Discard any water in the upper and lower
chambers and remove your existing spigot.
•Ensure that the top cap is securely tightened
by hand. A leak may occur at the base of the
glass tube if it is not secure.
•Place one stainless steel washer over the
threads of the spigot and position it so the
beveled side faces away from the stainless
steel chamber. (See image below)
•Then place one silicone washer over the
threads of the spigot.
•Insert the threaded end of the spigot through
the hole in the lower chamber of your
Berkey® System.
•Place the remaining silicone washer and then
the remaining stainless steel washer onto the
spigot threads inside the lower chamber.
Position the beveled side of the metal washer
away from the hole in the lower chamber. (See
first image)
•Secure the spigot in place with the nut.
Step 2
Step 3
•Ensure that the rubber base ring of your
Berkey® System is not pinched by the exterior
washers of the spigot.
•When the spigot is open, the arm will be
straight. When the spigot is closed, the arm
will be facing to the right. To avoid leaking,
ensure the spigot is in the closed position
when not in use.
•Your Stainless Steel Berkey Water View™
Spigot is now ready for use!
Step 1
•Remove the nut from the threaded end of
the spigot body, as well as the two stainless
steel washers, and the two silicone washers.
Remove the protective film on the stainless
steel washers. Unscrew the top cap on top
of the metal sleeve, being careful not to lose
the silicone washer inside the cap. Place the
glass tube somewhere safe so it does not
roll.
Step 2
•Clean parts in warm soapy water. DO NOT
LOSE THE SILICONE WASHER located
inside the top cap. The glass tube will leak if
the rubber washer is not in place.
• Hand wash only. Do not wash in a
dishwasher.
• A small soft brush may be used to
clean the inside of the glass tube.
Step 3
•Rinse and dry all parts.
•Insert glass tube into stainless steel sleeve.
•(Optional) Insert the blue float ball into the
glass tube.
•Ensure the silicone washer is in the top cap.
Securely tighten the top cap by hand.
•Move on to installation.
What’s Included
Nut
Spigot body
Top cap with
silicone washer
(2) Silicone washers
(2) Stainless steel washers
Stainless steel sleeve
with glass tube
Blue float ball