Kraus Fireclay Farmhouse KFR1-33GWH User manual

www.kraususa.com I Toll Free: 1.800.775.0703 I © 2018 Kraus USA Inc. I REV. September 23, 2019
Fireclay Farmhouse
Kitchen Sink
KFR1-33GWH
R
INSTALLATION MANUAL

Thank you for your purchase
We would like to take this opportunity to thank you for choosing Kraus.
We hope that you are completely satisfied with your purchase, and enjoy it for years to
come. If you have any questions, or require technical assistance, please contact us at
800.775.0703 and one of our representatives will be happy to help.
For more information about Kraus products, please visit:
www.kraususa.com
In order to activate your warranty and get faster access to customer support, please
register your new Kraus product at:
www.kraususa.com/registration
Sincerely,
Kraus USA Customer Service
2

3
Prior to Installation:
·Inspect the sink prior to installation to make sure the sink has not been damaged
during shipping.
·Observe all plumbing and building codes according to your state requirements.
·Additional floor and wall preparation may be required to avoid damaging the sink.
·Make sure to purchase the correct cabinet for your farmhouse sink. Farmhouse
base cabinets should be 3" larger than the actual size of the sink.
·Not recommended to be installed with laminate countertop.
For technical assistance or replacement parts, please contact Kraus
Customer Service and one of our representatives will be happy to help:
Toll-Free: 800-775-0703 or [email protected]
The step-by-step guidelines in the installation instructions are a general reference for
installing a Kraus Sink. Should there be any discrepancies, Kraus cannot be held liable. It is
recommended to install all Kraus products by hiring a licensed professional.

Tools you will need:
4
Parts List
·Sink
·Bottom Grid
NOTE: Specialized tools may be necessary to install Kraus Fireclay sinks with
countertop materials other than wood, marble or granite.
Phillips Screwdriver Pencil
Tape Measure Screwdriver Level
Safety Goggles Silicone Adhesive Jig Saw AcetoneDrill
33"
840mm
18 5/16"
465mm
30 1/4"
766mm
32 1/4"
820mm
10"
254mm
Dimensions
KFR1-33GWH
33" x 18 5/16"" x 10"
ACETONE
88° 88°

5
1. Measure & Build Supports
·Measure the actual height of apron
·Build supports on inside of cabinet based on sink measurements
Installer Tip: Support options
·1 1/4" Angle Irons
·(2) 2" x 4'
·3/4" Plywood
SUPPORTS
NOTE: Due to the typical ±3mm side
wall variance in manufacturing, it is
recommended that you design /
modify the sink cabinet to match your
clients individual sink(s) need.

6
2. Cut Cabinet Front
·Measure height of apron front. Add 1
16" to the dimension when you mark
base cabinet front cutout. Use jigsaw to cut.

7
3. Install Sink
·Place sink in opening. The weight of sink should be sustained
by the built supports.
·Make sure sink is leveled from front to back and side to side
·Uses silicone to fill in gaps where necessary
NOTE: This sink is reversible. Pick which apron you'd like facing forward before
installing.

8
4. Cut Countertop
·Due to the custom nature of this type of installation, no cutout template is
included.
·Kraus recommends providing the cabinet maker with the actual sink to
be installed prior to the cabinet fabrication.
·It is recommended that the sink be installed with an approximately 1/8"
positive reveal. It is further recommended that the installer(s) discuss this
with the customer and agree that this finished appearance is the desired
effect.

9
Installer Tip: Use acetone or denatured alcohol to remove any excess sealant.
5. Install Countertop
·Use a bead of silicone (or preferred adhesive) around the rim of the sink.
Check the alignment of the sink to the cutout in the countertop. Place
countertop cutout hole over sink and press firmly.
Silicone Adhesive

10
6. Installing Plumbing and Fixtures
·Connect drain, trap to drain and water supply connections to the faucet
according to manufacturer's instruction.
·Run water into sink and check for leaks.

11
Codes/Standards Applicable:
Fireclay Kitchen Sink Warranty
Kraus products are manufactured and tested to the highest quality standards by Kraus USA Inc. (“Kraus”).
Kraus extends this warranty to the original purchaser for personal household use of the “Fireclay Kitchen Sink” in its original
location. The warranty is non-transferable.
Kraus warrants the structure and finish of the product to be free from defects in material and workmanship under normal usage
for a period of five (5) years. The warranty commences from the initial date of purchase by the owner or trade professional,
from an authorized Kraus dealer, through the five (5) year term of the original owner or end-user.
Any product reported to the authorized dealer or to Kraus as being defective within the warranty period will be repaired or
replaced with a product of equal value at the option of Kraus. This warranty extends to the original owner or end-user, and is
not transferable
to a subsequent owner.
Restrictions
This warranty does not cover antediluvian, discontinued, or display products, whether such items are purchased at discount
outlets, unauthorized dealers, and/or sold on clearance.
This warranty does not cover instances of negligence, misuse, abuse, improper installation, carelessness, accident, hard
water or mineral deposits, exposure to corrosive materials, misapplication, damages caused by improper maintenance,
alteration of the product, or failure to follow care or installation instructions enclosed with your product. Avoid using abrasive
cleaners such as powders, bleach, ammonia, alcohol, or chlorine. Avoid using abrasive pads, steel wool, or wire brushes, as
these will damage and wear down the finish.
This warranty does not apply to Products that have not been installed or operated in accordance with instructions supplied by
Kraus and all applicable rules, regulations, and legislation pertaining to such installations.
This warranty does not apply unless the Kraus product is installed by a fully insured and licensed trade professional. Kraus
insists that such professionals have experience in the installation of bathroom and kitchen manufactured goods.
This warranty does not cover labor charges or costs of removal and reinstallation of said product. This warranty does not allow
recovery of incidental or consequential damages, such as loss of use, delay, property damage, or other consequential
damages, and Kraus accepts no liability for such damages.
This warranty does not cover Marine or Outdoor Installation.
This warranty does not cover any free gifts included with purchase.
Except as otherwise provided above, Kraus makes no warranties, expressed or implied, including warranties of
merchantability and fitness for a particular purpose, or compliance with any code.
Shipping charges will be covered for the first (1) year of the warranted replacement part or product (HI, AK, and Puerto Rico
shipping charges may apply). International shipping fees are not included.
UPC
CR

12
Commercial Warranty
Kraus extends the above warranty for a period of one (1) year to purchasers of products for industrial, commercial, and
business use.
All incidental or consequential damages are specifically excluded. No additional warranties, express or implied, are given,
including but not limited to any implied warranty of merchantability or fitness for a particular purpose.
Some states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an
implied warranty lasts, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
KRAUS USA has the right to change, modify, and/or update the warranty policy at any time. For the latest, most up to date
comprehensive warranty, go to www.kraususa.com/warranty.
HELP LINE
Our customer service hours are Monday - Friday, 9am - 8pm EST.
Be sure to visit our website at www.kraususa.com.
If you are a HOMEOWNER, please contact a Kraus Customer Service Representative at:
Kraus USA, Inc.
12 Harbor Park Drive
Port Washington, NY 11050
Toll-Free : 800-775-0703
[email protected]
If you are a PLUMBING CONTRACTOR OR TRADE PROFESSIONAL, please contact a Kraus Pro
Representative at:
Kraus USA, Inc.
12 Harbor Park Drive
Port Washington, NY 11050
516-801-8955
[email protected]
If you are an AUTHORIZED PARTNER, please contact a Partner Support Representative at:
Kraus USA, Inc.
12 Harbor Park Drive
Port Washington, NY 11050
516-801-8954
[email protected]
In requesting warranty service, please be ready to provide:
1. Proof of purchase.
2. A description of the problem.

Register Your Kraus Product
Activate Your Warranty
Access Premium Customer Support
Get Product Information
REGISTER TODAY
http://www.kraususa.com/registration
R
www.kraususa.com
IMPORTANT