BERNSTEIN EX506 User manual
SHOWER ENCLOSURE EX506
ASSEMBLY INSTRUCTIONS
September 2017
2
Shower enclosure EX506
TOOLS REQUIRED
INCLUDED IN THE DELIVERY
3
Please x the screws on the surface of the glass manually, not by power drill.
Wall proles should be arranged 15 mm to the external border of the shower tray, or according to the approximate value
of the segment A (see image below)
Upward arrow No arrow – Usable on both
sides
Please carefully consider that some of our shower enclosures are reversible.
In these cases no label will show the internal and external parts.
NOTE
WARNING
4
Shower enclosure EX506
Arrange the proles (see image). Mark holes position by means of a sprit level and a pencil.
Drill the holes and x the proles by means of the wall plugs. Please use wall plugs compatible with your wall.
ASSEMBLY:
5
Secure the aluminium prole to the rail with some screws 4*30. (As showed in the image)
6
Shower enclosure EX506
Insert the glass elements in the aluminium rail. (See image below)
Make sure to place the glass in the wall prole and, only later, place the joints between the glass and the prole, sliding
them from the upper to the downer side.
Slide the joint
between the glass
and the prole.
7
Insert the corner in the wall prole (See image)
8
Shower enclosure EX506
Connect the two elements by means of the plastic supports. (See image below)
9
Install the wheels with the button downside and without button upside.
NOTE:
The upside wheels are adjustable. They can be adjusted by means of a hex screwdriver if they were not sliding correctly.
10
Shower enclosure EX506
Place the door on the aluminium rail.
Pushing the button on the wheels the glass
will be easy to clean.
11
1. Fix the magnetic joints to the door
2. Place the joints between the door and the aluminium prole
3. Drill the holes and connect the glass segment to the wall prole, by means of the screws 4x16
4. Place the cover on the screws
12
Shower enclosure EX506
1. Fix the wheels block on the rail
2. Screw the door handle
3. Install the joints to the xed panel and the door
4. Put the protection cover on the aluminium prole.
5. Apply silicone sealant
Other manuals for EX506
1
Table of contents
Other BERNSTEIN Other manuals
