Bert Frank STASIS User manual

-Lift up top cup.
12
- On the lamp base unscrew the 4 countersunk screws.
STASIS
FLOOR LAMP
- Lacquered brass should be wiped with a soft duster.
- 1 x ES LED
www.bertfrank.co.uk
[phone]
MAINTENANCE
TECHNICAL
INSTALLATION
- Insert the arm through the slot in the back of the base.
34- Sliding the arm through the slot in the top cap
replace top cap.

5
6
- Tighten up the 4 countersunk screws to required
tension to hold arm with adjustment possible.
INSTALLATION CONTINUED
This product is only suitable for connection to the native power supply to which the unit was specically manufactured. It is for indoor
use only, and not suitable for a bathroom location.
If the Class II, double insulated symbol is on the lamp, it does not require an Earth, and Live or Neutral must not be connected to Earth.
If there is no such symbol, then the lamp must be Earthed.
Never t bulbs of a higher wattage than those specied on the label, as these may cause overheating and damage the tting.
Under no circumstances must this table lamp be covered with any material as this could pose a safety hazard. It must be used on a
stable, at surface.
If the mains cable becomes damaged it must only be replaced by a technically competent, qualied person.
Allow 10 minutes to cool before replacing, adjusting or cleaning. Clean with a dry cloth only. Do not use liquid or abrasive cleaners on
this product.
If you are in any doubt about your competence please consult a qualied electrician. If any modication is made it will invalidate the
warranty and may render the product unsafe.