Safavieh Lighting ELIS FLL7000A User manual

NOTICE
* Please make sure that you have all parts indicated and they are in good condition before you begin assembly of this item.
Refer to part list and hardware list below for guidance.
* This item should be assembled on a soft surface to prevent scratching the finish during assembly.
* This item may require periodic tightening.
PREPARATION
Model#FLL7000A
Product Dimensions:
12"Lx41.7"Wx76.5"H
*Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and
hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 10 minutes.
* If you are having difficulty, our friendly Customer Care team is always here to help.
Please email [e-mail].
CARE AND MAINTENANCE
Unplug lamps before using any cleaning solutions. Dust shades with a feather duster or with an appropriate
vacuum_brush attachment. Wipe with a soft, dry cloth and clean lamp bases with the methods appropriate to the
material.Avoid the use of chemicals and household cleaners as they may damage the finish.
Part List and Hardware List
PEICE
DESCRIPTION
PICTURE
QUANTITY
PEICE
DESCRIPTION
PICTURE
QUANTITY
HW1 Jam Nuts
⊘12MM 1X I Pipe 4 1x
HW2 Tooth Lock washer
⊘13MM 1X J Pipe 5 1x
C Lamp Base 1X K Shade 1x
D Pipe 1 1X L Lock Ring 1x
E Pipe 2 1X M Bulb 1x
G Pipe 3 1X HW5 Allen Key 1x
HW3 Screws ⊘ 4mm 3X HW6 Allen Key 1x
HW4 Phillips Screws ⊘
4mm 3X HW7 Wrench 1x
1/2

PREPARATION
* Before beginning assembly of product, make sure all parts are present. Compare parts with part contents list and hardware contents list.
* If any part is missing or damaged, do not attempt to assemble the product.
* Estimated Assembly Time: 10 minutes.
Step 1:Install the pipe 1(D) into the base in front side, and
locked it into the base(C) with nuts(HW1) and tooth lock
washer (HW2),fix them tightly with wrench(HW7). Install the
pipe 2(E) into pipe 1(D), then install the pipe 3(G) into pipe 2(E),
lock the pipe 3(G) with screws(HW3) and fix with the allen
key(HW6). Lock pipe 4(I) into pipe 3(G), fix it with phillips
Screws(HW4) and fix with allen key(HW5). Install pipe 5(J) into
pipe 4(I) and lock it with phillips Screws(HW4) and fix with allen
key(HW5). Check the floor lamp and ensure is front side and
upright to the floor.
Step 2: Install the shade(K) to the socket and lock it with the ring(L). Step 3:Install the light bulb(M) into the socket.
2/2