Bert Frank MASINA User manual

MASINA
FLOOR LAMP
- Lacquered brass and glass should be wiped with a soft duster.
- 1 x E27 LED bulb (UK/EU)
or
- 1 x E26 LED bulb (USA)
www.bertfrank.co.uk
[phone]
INSTALLATION
MAINTENANCE
TECHNICAL
12- Insert the fixing ring into the main shade.
- Secure the shade collar to the fixing ring using
the screws.
inside shade
- Firstly, separate the shade collar and fixing ring by
removing the screws.
12- Guide the white washer down through the shade.
- Screw the thumb screws through the white washer
and into the gallery to sandwich and secure the
shade in place.
- Holding the base of the lamp, guide the neck of the
shade onto the gallery section of the base.
- This will need to be held together and supported
throughout stage 2.
gallery
A
B
B
A

1
2
- Turn off the light at the mains.
- Replace bulb by screwing it into lamp holder.
BULB REPLACEMENT
This product is only suitable for connection to the native power supply to which the unit was specifically manufactured. It is for indoor
use only, and not suitable for a bathroom location.
If the Class II, double insulated symbol is on the lamp, it does not require an Earth, and Live or Neutral must not be connected to Earth.
If there is no such symbol, then the lamp must be Earthed.
Never fit bulbs of a higher wattage than those specified on the label, as these may cause overheating and damage the fitting.
Under no circumstances must this table lamp be covered with any material as this could pose a safety hazard. It must be used on a
stable, flat surface.
If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person.
Allow 10 minutes to cool before replacing, adjusting or cleaning. Clean with a dry cloth only. Do not use liquid or abrasive cleaners on
this product.
If you are in any doubt about your competence please consult a qualified electrician. If any modification is made it will invalidate the
warranty and may render the product unsafe.