BetaLife GARRETT 21995 User manual

Assembly Instrustions
we strongly recommend that the product is assmbled on a flat and smooth surface and keep on the same horizontal
line,otherwise,there will be a phenomenon of screw dislocation and cannot be installed
Quicker assembly, we recommend the use of a power drill
on a low-speed setting
Thank you for your purchase.
please follow the instructions below for correct assembly.
GARRETT 8 Drawer Tallboy
Code:21995

2
A68set 9pcs 8pcs 8set
5pcs 1pcs
35*3.5
2pcs 8pcs 68pcs
14*3.5
BCDEF
LG H K
F2
F1
I J
92pcs 32pcs
2pcs

L
A
3
01 02
03 04
Ax4 Lx4 Ax4 Lx4
Ax12 Bx9 Cx20 Gx5 Lx12

F1
4
05 06
07 08
Dx32 F1x16 Hx1 Cx8 Ix2 Jx2 Kx8
Ax6 Cx4 Dx2 Ex1 F2x2 Lx6

5
SURFACE CARE INSTRUCTIONS
CAUTION
A little care and attention will extend the life and good looks of your furniture.Take care when using materias which might spill,
or be sharp or abrasive,on the surface of your furniture.
Normal Cleaning: For normal cleaning use a soft, dry, cleancloth. Glass Cleaning for Frosted Glass:Do not use glass cleanef
of solvent based cleanerson glass that has a frosting effect on it.
Normal Glass Cleaning:You may use normal glass cleaning products on all other types of glass,Use a soft non-abrasive cloth
to remove light dust and finger prints
Leather & Vinyl Cloth Cleaning:Under no circumstances should any abrasive materials be used on these surfaces, as it will
result in irreparable damage.prints.
Do not use solvents,solvent based cleaners,scouring pads,steel wool or scrubbing brushes to clean this furniture item.
Only use a slightly damp, soft,clean cloth on this surface if cleaning is needed.Do not scrub
1.When moving this furntiuye item,please always hold up product.Dragging or sliding could damage the product itself and
the floor surfsce
2.As with all furniture,this unit should not be exposed to direct sunlight,extreme temperatures or moiture,as this can result in
irreparable damage.
3.Be sure to protect the floor,wall or surrounding furniture with a carpet,blanket or shock-absorbing materials during assem-
bly in order not damage them.