Better Music Builder DFS-206 User manual

©2007 Better Music Builder. All rights reserved.
Installation
®
TMTM
®
1. Mounting the Speaker to the
Ceiling
First hold the speaker bracket
under the ceiling, then screw the
bracket into the ceiling wall.
Unscrew the two alan screws
found on the center of both the
speaker sides. Place a rubber
gasket for the sound quality, and
screw the speakers back into the
brackets as shown in the diagram
below.
We recommend that you
seek professional installation
service for your protection and
safety.
NOTE
8mm
expanding bolt
8mm screw8mm
screw Rubber
gasket
Rubber
gasket Speaker
Bracket Included

©2007 Better Music Builder. All rights reserved.
Installation
®
TMTM
®
When installing the speakers
to the brackets you must
insert a rubber gasket to
protect speaker sound quality.
woodscrew
woodscrew
2. Mounting the Speaker to the Wall
You may use wooden or concrete
screw depending on the wall’s
material for installation. Use
woodscrew for wood wall and
concrete screw for concrete wall. The
screw size is 8mm for both wooden
and concrete screws.

©2007 Better Music Builder. All rights reserved.
Installation
®
TMTM
®
NOTE
3. Monitor Speaker
When you use this speaker as a
center speaker or “monitor”
speaker, this speaker has 4
plastic washers screws on the
bottom of the speakers to
prevent extreme shaking from
recoil. You may use the bracket
to mount the speaker tightly
onto the floor or ground.
Therefore, the speaker is firmly
held even with extremely loud
music.
We recommend all users
to seek professional advise for
safety purposes when mounting
the speakers onto floor or
ground.
Ground or Stage
Plastic washer