Big Sky TOWER 60D User manual

RESORT EXTRUSIONS
BIG SKY TOWER 60D  4FT X 14FT BACKLIT
PRODUCT CODE: BIGSKYT60D4X14-LLFRM

Page 1 of 2
SET UP INSTRUCTIONS 1/2
2. Locate the Bottom and Side Extrusions:
3. Locate the Top and Side Extrusions:
1. Attach Split Connectors to Side Extrusions:
a. Remove the screw and insert split connector
into one end of the extrusion. Match like colored
numbers together. (e.g. 3-3, 4-4).
b. Tighten screw to lock it into place. Remove
the remaining screw from the connector.
c. Then slide the other extrusion onto split
connector. Make sure extrusions are ush
and tighten the screw to secure connection.
c. Connect horizontal extrusion to
the bottom of a vertical extrusion,
screw facing inward.
d. Connect bottom extrusions to-
gether and use torx key to tighten.
a. See colored numbers on each
extrusion piece. Match like colored
numbers together. (e.g. 3-3, 4-4).
a. See colored numbers on each
extrusion piece. Match like colored
numbers together. (e.g. 3-3, 4-4).
b. End Lock is already attached to
opposite ends of extrusion.
c. Connect horizontal extrusion
to the top of a vertical extrusion,
screw facing inward.
d. Connect the top extrusions to-
gether and use torx key to tighten.
b. End Lock is already attached to
opposite ends of extrusion.
a. End Lock is already attached to opposite
ends of Support Strut.
b. Align Support Struts within marked
lines, and insert End Lock into top and
bottom grooves of frame.
c. Add a second support strut to align
marked lines and tighten screws with torx
key to secure connection.
4. Attach Support Strut to Frame:
RESORT EXTRUSIONS
BIG SKY TOWER 60D  4FT X 14FT BACKLIT
PRODUCT CODE: BIGSKYT60D4X14-LLFRM

RESORT EXTRUSIONS
SET UP INSTRUCTIONS 2/2
6. Hook Ladder Lights:
a. Place extrusion with the light hooks on
top of the extrusion and connect together.
c. The transformer comes pre-wired. Connect
the wiring from transformer to the 2 plugs at
the bottom of the ladder lights.
b. Hang ladder LED lights on hooks and
drape them down inside the wire.
5. Attach Light Hooks:
a. Eye Hooks: Insert light hooks into the
groove in one end of the extrusion.
b. Slide the light hooks into the groove and
place them in the center. Tighten Hook.
c. Make sure light hooks are place far
apart for hooking the LED Ladder Lights.
Page 2 of 2
RESORT EXTRUSIONS
BIG SKY TOWER 60D  4FT X 14FT BACKLIT
PRODUCT CODE: BIGSKYT60D4X14-LLFRM