bily EASY-GO PLAYARD User manual
EASY-GO
PLAYARD
with Bassinet & Changer
BP1211GR_IM (May 2019)
Please Note: Instructional images may vary
in style from the product you purchased.
ELFE JUVENILE PRODUCTS
2520 AVE MARIE-CURIE
SAINT-LAURENT
(QC) H4S 1N1
1-800-667-8184
service@elfe.ca
www.elfe.com
English
1
(H) Long Side Rails (X2)
(F) Long Changer Tube E
Parts List
(A) Playard
(G) Bassinet Attachment
(J) Mattress Pad (K) Travel Bag
(L) Toy Bar
(B) Changer
(C) Short Changer Tube C1
(E) Long Changer Tube D
(I) Short Side Rails (X2)
(D) Short Changer Tube C2
NOTE: clip position on tube C1, C2 and E
should be facing outwards
WARNING
FAILURE TO FOLLOW THESE WARNINGS AND THE INSTRUCTIONS COULD RESULT IN SERIOUS
INJURY OR DEATH. IF YOU CANNOT EXACTLY FOLLOW THE ACCOMPANYING INSTRUCTIONS,
THEN DO NOT USE THIS PRODUCT.
Setting Up the Playard
use. Check that the four top rails are completely latched, the center of the floor is pushed
down, and the mattress/pad is flat and secured by the hook and loop straps. Always
follow the instructions in the owner’s manual to set up the playard.
parts or torn mesh. Check before assembly and periodically during use. Contact Elfe
Juvenile Products at 1-800-667-8184 for replacement parts and instructions if needed.
Using the Playard
necessary for the continued safety of your child.
could serve as steps for climbing out.
including an add-on bassinet.
wrapped around a child’s neck.
cord of a blind or curtain and be strangled.
2
!
Playard
WARNING
3
!
Playard
missing or if there are any signs of damage.
instructions are needed.
floor pad in this playpen.
position before placing a child in it.
use. Check that the four top rails are completely latched, the center of the floor is pushed
down, and the mattress/pad is flat and secured by the hook and loop straps.
Using the Playard
safety of your child.
serve as steps for climbing out.
including an add-on bassinet.
whenever child is in product.
This product is not intended for commercial use.
4
Setting up the Playard
unit upright. Separate the velcro tabs.
2. Remove mattress pad.
5
Setting up the Playard
it locks into position.
4. Lift the side rails upwards from the
middle until each lock into position.(4A)
Side rails must be raised above
4A
4B
6
Setting up the Playard
Parts Needed:
6. Lay mattress pad on floor of playard,
softside up.
mattress pad through each slot in the
playard and attach the velcro under the
playard.
8. The playard is now ready for use.
(A) Playard (J) Mattress Pad
WARNING
SERIOUS INJURY OR DEATH. IF YOU CANNOT EXACTLY FOLLOW THE ACCOMPANYING
INSTRUCTIONS, THEN DO NOT USE THIS PRODUCT.
wrapped around a child’s neck.
missing or if there are any signs of damage. Do not substitute parts. Contact the
manufacturer if replacement parts or additional instructions are needed.
mattress pad in this accessory.
of a blind or curtain and be strangled.
mattress to this bassinet.
7
!
Bassinet Attachment
8
1. The bassinet is to be attached to
to the playard at the designated
starting point. The warnings on the
bottom of the bassinet should be
facing up.
completely, attach the bassinet to
the playard with the clip. Folding the
Assembling the Bassinet Attachment
Parts Needed:
(A) Playard (J) Mattress Pad
(G) Bassinet Attachment
(H) Long Side Rails (X2) (I) Short Side Rails (X2)
9
on the bottom of the bassinet
attachment before connecting the
bassinet rails into one another.
4. Connect the long rails to the
short rails.
the tubes and tuck the four corners
in. Smooth out the surface of the
mattress.
Assembling the Bassinet Attachment
WARNING
10
!
Changer
11
1. Place the tubes C1, C2, D, E, and changer
fabric on the floor with clips facing outwards
as shown in picture 1.
2. Insert the four tubes through the changer’s
fabric slots with plastic clip facing outwards.
(picture 2)
4. The assembled changer. (picture 4)
Assembling the Changer
Parts Needed:
(A) Playard
(B) Changer
(F) Long Changer Tube E
(C) Short Changer Tube C1
(E) Long Changer Tube D
(D) Short Changer Tube C2
C1
C1
D
D
E
E
C2
C2
2
1
3 4
NOTE: clip position on tube C1, C2 and E should be facing outwards
12
8. Push down on changer connectors to snap
changer into playard.
Assembling the Changer
7. Fasten the changer’s clips onto playard.
the two plastic clips on the short side of top
6. Clip the 2 remaining plastic clips on the
long side long side of the playpen (picture 6).
5
7
6
8
13
1. Place toy bar over the playard.
2. Press down on toybar handles to clip
onto playard frame.
Assembling the Toybar
Parts Needed:
(A) Playard
(L) Toy Bar
14
To Fold the Playard for Storage
2. Remove mattress pad in order to release
locking mechanism.
1. Release the velcro tabs under the playard.
release the lock. Then pull up the base
of each end rail and release downwards.
Repeat for each side rail.
15
to Fold the Playard for Storage
6. Lay mattress pad on floor - soft side up -
around playard and fasten the velcro tabs.
8. The playard is now ready for easy
carrying or storage.
16
Cleaning
Do not bleach.
Special Instructions
-This playard is guaranteed to meet all federal and provincial standards and will provide
many years of service provided you adhere to the guidelines provided for assembly,
maintenance and operation.
-For parts or assistance, do not return to retailer where playard was purchased.
Call or write Elfe Juvenile Products.
Limited Warranty
1 Year Limited Warranty
Elfe Juvenile Products will supply the original owner, without charge, any part discovered
to be missing at the time of purchase or found to be broken or defective during the 1 year
warranty period.
The warranty begins on the date of purchase, as established by your purchase receipt.
The model number, date of manufacture, and the part description must be provided.
The warranty does not apply to defects caused by owner damage, product alteration, or
unreasonable use. This warranty gives you specific legal rights that may vary from province
to province.
17
Important Information:
Before you begin assembly, please read these directions. Store this instruction manual in
the pocket located under the mattress pad, for future reference.
parts to the store where they were purchased before calling us. Please call us toll free at:
1-800-667-8184
Our service is fast, free and easier than returning the product.
Important: In order to help our customer service representatives better assist you,
we require that you complete the information below before calling:
Date:
Model Number and Manufacturer’s Date can be found
on the tubular structure under the playard.
ELFE JUVENILE PRODUCTS
2520 AVE MARIE-CURIE
SAINT-LAURENT
(QC) H4S 1N1
service@elfe.ca
www.elfe.com
1-800-667-8184
ELFE JUVENILE PRODUCTS
2520 AVE MARIE-CURIE
SAINT-LAURENT
(QC) H4S 1N1
service@elfe.ca
www.elfe.com
1-800-667-8184
This manual suits for next models
1
Table of contents
Other bily Baby & Toddler Furniture manuals
Popular Baby & Toddler Furniture manuals by other brands
Baby Trend
Baby Trend Lil' Snooze Deluxe III PY86 H Series instruction manual
babyplus
babyplus Abel Assembly instructions
DaVinci
DaVinci Jenny Lind M7398 manual
topmark
topmark SKY Instructions for use
DaVinci
DaVinci Elizabeth II Assembly instructions
dreambaby
dreambaby Arizona Extenda-Gate F2164 instructions
Baby Trend
Baby Trend Deluxe PY71A48A instruction manual
topmark
topmark CHARLIE Instructions for use
Little Seeds
Little Seeds 5717872COM Assembly manual
Baby Trend
Baby Trend Lil Snooze Deluxe II RC86 C Series instruction manual
Bellamy
Bellamy DAFI instruction manual
Baby Trend
Baby Trend PY75 A Series instruction manual