Bison BA803 ADPT User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A1BA803 Adapter Brackets (1 Left & 1 Right) B45/16” X 2 1/2” Hex Bolt
C41/4” X 1 1/4” Special Bolt (BAACRYLIC) D41/4” Flange Nut (BAACRYLIC)
E1Backboard F1Backboard Support Plate (BA803 Instruction Item O)
—— Instruction Manual ——
BA803 ADPT
Adapter for 46A Backboard
Date: 04/16/2019 Rev: 1 B.A. N.J.C. File: F\PUB\INSTR\PORT.BASES\BA803ADPT Ref#: 930748
Customer Service
[phone]
Note:
Refer to the BA803 instructions for Base Assembly prior to Backboard Installation.
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.
 Read all instructions before proceeding.
Note:
The 5/16” X 3 1/2” Carriage Bolts (H) included in the BA803 Hardware
are not used for this application.
1. Using the 1/4” X 1 1/4” Special Bolts (C) and the 1/4” Flange Nuts (D) bolt the BA803 Adapter
Brackets (A) to the Backboard (E). Leave bolts finger tight. See illustration on page 2 for correct
orientation of the BA803 Adapter Brackets (A).
2. Bolt the Backboard (E) assembly to the Adjustable Poles ( Item (D), BA803 Hardware) using the
5/16” X 2 1/2” Hex Bolts (B), 5/16” Flat Washers (Item (I), BA803 Hardware), 5/16” Lock
Washers (Item (J), BA803 Hardware), and the 5/16” Hex Nuts (Item (K), BA803 Hardware). See
Illustration on page 2.
3. Tighten all hardware.
Note:
Refer to the BA803 instructions to finalize assembly.

2
A
B
C
D
E
F
This surface
facing out
This end down