Bison PK10 User manual

1
P A R T S L I S T
Item Qty Description Item Qty Description
A2Pickleball Post D2PK21 Floor Socket (optional)
B1Pickleball Net E2BM300A, BM350A or BM400A Post Adapter (optional)
C1Center Net Hold Down
 Inspect all contents prior to installation. Report any missing parts to dealer immediately.
 Read all instructions before proceeding.
—— Instruction Manual ——
PK10
PE Pickleball System
Date: 08/27/2021 Rev: 3 N.J.C. File: \pub\pk10uinst Ref#: 960902
Customer Service
[phone]
1. For permanent installation dig 8" diameter holes 36" deep and 22
feet apart. Make sure the top of Pickleball Posts (A) are 36" above
the playing surface, net tie cleats square to the playing surface and
the Pickleball Posts (A) are level. Fill hole with concrete. See
Figure 1, 3 and Pickleball Court Diagram on the back page.
2. Purchase optional PK21 Floor Sockets (D) for removable
Pickleball Post (A) installation. Dig 8" diameter holes 36" deep and
22 feet apart, fill with concrete. Insert PK21 Floor Sockets (D) into
the wet concrete. Make sure PK21 Floor Sockets (D) are square
and flush to the playing surface. Make sure to keep wet concrete out
of the PK21 Floor Socket (D). Use the bottom adjustment pad to
achieve 36" Pickleball Post (A) height. See Figure 2, 3 and
Pickleball Court Diagram on the back page.
3. Use BM300A, BM350A or BM400A Post Adapters (E) (not shown)
to set up a pickleball court on an existing indoor volleyball court
with existing volleyball post sockets. BM300A, BM350A or
BM400A Post Adapters (E) are available for 3", 3 1/2" or 4"
sockets.
4. Run both ends of the top rope of Pickleball Net (B) through the
groove in the top of Pickleball Post (A) and pull through net tie
cleats. Tie off the bottom of Pickleball Net (B) on the bottom net tie
loops. (B). See Figure 3.
4. Clip Center Net Hold Down (C) to the bottom center of Pickleball
Net (B) and adjust until the center of Pickleball Net (B) measures
34" from the playing surface. See Figure 3.
Figure 2
8"
36"
Figure 1

2
Floor Surface
A
B
C
22'
Net Tie Cleat
Bottom Adjustment Pad
Figure 3