Black Box Agility User manual

Agility and iPATH rack mount
1
2
1
2
Quick Start
Using the Agility and iPATH rack mount
1 Install the empty rack mount tray into your 19” rack frame and fully secure it.
2 Place Agility or iPATH units into each side of the rack mount tray so that their rear panels
butt up against the small pegs located on each of the side walls.
3 Locate the supplied thumbscrew and spacer.
4 Insert the thumbscrew through the spacer; then insert into the small hole at the end of the
center divider (A).
5 Gently tighten the thumbscrew so that the spacer engages with the inner edges
of the two units and holds them in place (B).
6 Place the power adapters in the rear section of the rack mount tray
and connect them to their respective units.
7 Make all other necessary connections to the units.
(A) (B)
See overleaf if installing a single iPATH unit.

1
2
Using a blanking plate when a single unit is installed
In order to maintain suitable cooling airow, if a single Agility or iPATH unit is installed within the
rack mount, you are recommended to install an optional blanking plate: ACR-RMK2-BP
Note: The outer edge of the blanking plate needs to overlap the ears of the rack mount
tray itself, so you need to either install the blanking plate before the tray is installed
or briey remove the mounting bolts on the blanked side (while supporting
the weight of the tray) to allow the blanking plate to be put in place.
ACR-RMK2-BP
blanking plate
MAN-QS-000063 Rev 0.2
Order toll-free in the U.S. or for
FREE technical support 24/7: Call 877-877-BBOX
(outside U.S. call 724-746-5500)
www.blackbox.com • [e-mail]