8. Key on Trigger Zone
•
•
9. Manual Override System
•
10. Ignition / Starter Disable (External
Heavy Duty 30A Relay)
•
11. 3 Independent Triggering Zones
with Memory
•
•
•
FUNCTIONS
Press Button 1 to arm.
The central lock will be lock, alarm will
beep once, hazard light ashes and LED
light will turn on.
The immobilizer will function if the
ignition is turned ON.
Press Button 2 to disarm.
The central lock will be unlocked and
alarm will beep twice.
Hazard light ashes twice and LED light
will turn o.
Press Button 1 and 2 simultaneously to
disable Beep sound, hazard light will
ash twice.
Repeat the same step to enable the
Beep sound.
The alarm will beep and hazard light
will ash.
Press Button 4 to trigger the alarm and
hazard light for approx. 45 sec. instantly
in case of emergency.
Press buttons other than Button 4 to turn
o the alarm, alarm system will remain
armed and locked.
After 30 seconds of disarming the alarm
system and no doors are being open, the
system will automatically relock / rearm
the vehicle.
If the central locking was accidentally
unlocked after 15 sec. second alarm will
beep and hazard light ashes, indicating
the system will be rearmed and the door
will be relocked in another 15 sec.
To disable this function, turn on the
ignition, press and hold Button 1 for
2 sec., the alarm will beep twice and
hazard light ashes.
Repeat the same step to enable this
function again, alarm will beep once and
hazard light ashes.
This function will be activated either
after the ignition is turned o for 60 sec.
at disarm mode or 60 sec. passed after
Button 2 is pressed.
The passive immobilizer sends out signal
to stop the electronic start/ ignition
circuit in order to immobilize the vehicle.
The blinking LED indicates the function
is enabled.
To Cancel the passive immobilizer, press
Button 2; the LED will stop blinking
indicating the function is disabled.
Note : The auto-relock function will over-
ride passive immobilizer function.
The alarm will be triggered if any zones
are opened while the alarm status is in
armed mode.
The siren will last for 45 sec. and 5 sec.
break, every time the system check for
the zone status.
Upon completion of 3 zone status check-
ing, the violated port is ignored and the
system will be rearmed.
1. Arm (Lock)
•
•
•
2. Disarm (Unlock)
•
•
•
3. Beep Sound (Remote Selection)
•
•
•
4. Panic
•
•
5. Auto Relock/ Auto Rearm
(Remote Selection)
•
•
•
•
6. Passive Immobilizer
•
•
•
7. Doors/ Boot/ Bonnet Zone Protection
•
•
•
3
FUNCTIONS
The alarm will be triggered if the alarm is
in arm mode and the ignition is ON.
The siren will continue for 45 sec. before
it takes 5 sec. to check on the ignition
status, the siren will continue if alarm is
still in arm mode while ignition is ON.
To set o the alarm system without
using a the remote in case of missing/
malfunction remote, turn on the ignition
and press the Reset switch once.
When the alarm system is in arm mode
and ignition is ON, the system will halt
the ignition (subject to relay connection)
and the alarm will be triggered. This will
immobilize the vehicle to prevent car
from being stolen.
There are sensors on the doors/ bonnet/
boot & ignition key zones.
The alarm will beep 3 times after the
alarm is disarmed, indicating doors/
bonnet/ boot zone is triggered; 4 times
indicate sensor, 5 times indicate ignition
key zone triggered.
The memory will automatically be
erased when the ignition is turned on in
disarm mode.
A dashboard mounted red arm and
memory LED will light up to indicate
when the alarm system is arm, disarm,
triggered.
To turn on the Valet Mode, then the
ignition ON, press Button 1 and 2 for
hold for 2 sec., the alarm will beep once
and hazard light ashes, the arm LED
ashes too.
The alarm system will be disabled when
in valet mode (Not include Central Lock
System).
To return to normal mode, repeat the
same steps again while the ignition
is ON.
In disarm mode, when the alarm system
detects opened doors and the ignition is
ON, the hazard light ashes.
The hazard light will stop ashing when
the doors are closed.
When door lock mode is activated, alarm
will beep and hazard light ashes when
the doors are opened.
After 30 sec., the alarm will be trigger.
To disable this function, follow the Exit
Delay Time Selection.
12. LED Indicator shows the Status of
the Security System
•
13. Valet Mode (Remote Selection)
•
•
•
14. Door Open Detection
•
•
15. Opened Door Warning (Remote
Selection)
•
•
•
4
