Blue Expert BED009 User manual

BlueExpert BED009 Bluetooth EDR Dongle
User manual
BED009 User Manual 1

Host Requirements
zIBM compatible PC with Pentium, CeleronTM processor or equivalent CUP or
higher.
zRAM 64M or above.
zScreen : 800*600 or above.
zDisplay : Adapter True Color 16bits or above.
zMicrosoft® Windows®98SE/ME/2000/XP
Contents for each package
zInstallation CD ROM or setup disks for Windows98SE\ME\2000\XP (IVT or
Toshiba).
zBluetooth device : BED009.
zUser manual.
Installation Steps
zIf a previous version of IVT or Toshiba or Widcomm BTW has been installed, it
is recommended to uninstall it first and restart the computer before installation.
zInsert the Installation software CD into the CD-ROM of your machine, you can
follow the instructions to finish the BT software installation.
zPlug the BED009 into the USB port of a PC and the BT software would
auto-detected the device BED009.
BED009 User Manual 2

zAfter reboot the computer, and start the BT software. At the same time, User
could use BT software and connect with other BT device by BED009.
Notice on FCC
15.21
You are cautioned that changes or modifications not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
BED009 User Manual 3

Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
BED009 User Manual 4