Blue Water Toys BWDK-886 User manual

Inflatable Floating Deck
OWNER’S MANUAL
WARNING:
Read carefully and understand all ASSEMBLY AND OPERATION
INSTRUCTIONS before operating. Failure to follow the safety rules and other
basic safety precautions may result in serious personal injury.
Model # BWDK-886
Model # BWDK-76766
Model # BWDK-586
Model # BWDK-76766R

2
Thank you very much for choosing this Blue Water Toys product! For future reference, please
complete the owner’s record below:
Model:_______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This product is designed for certain applications only. The manufacturer cannot be responsible
for issues arising from modification. We strongly recommend this product not be modified and/or
used for any application other than that for which it was designed. If you have any questions
relative to a particular application, DO NOT use the product until you have first contacted us to
determine if it can or should be performed on the product.
For technical questions please call 1-952-953-6140.
TECHNICAL SPECIFICATIONS
GENERAL SAFETY RULES
WARNING: Read and understand all instructions. Failure to follow all instructions listed
below may result in serious injury.
CAUTION: Do not allow persons to operate or assemble this Floating Deck until they
have read this manual and have developed a thorough understanding of how the Floating
Deck works.
WARNING: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions or situations that could occur. It must be
understood by the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Max Capacity Deck Dimensions
BWDK-886 1000 lbs 8’ x 8’ x 6”
BWDK-76766 1000 lbs 7’6” x 7’6” x 6”
BWDK-586 750lbs 5’ x 8’ x 6”
BWDK-76766R 1000 lbs 7’6” diameter x 6”
Material Drop Stitch with Laminated UV Resistant PVC

3
SAVE THESE INSTRUCTIONS
PERSONAL SAFETY
•ALWAYS use extreme caution when using this product. Acting in a careless manner or
misusing the product may result in serious injury or death.
•Consult your physician before using this Floating Deck. Use this product only if you are in
good physical health. User must know how to swim.
•DO NOT exceed the Floating Deck weight capacity. Proper distribution of weight is necessary
to ensure proper balance and performance.
•Users are responsible for their own safety and the safety of others when using this product.
•Check your local city and state laws and ordinances for licensing rules.
•Users of this product must be 18 years of age or must have a legal guardian read these
warnings and safety precautions. Do not use this product without adult supervision.
•DO NOT use this product while under the influence of alcohol, drugs or medications.
•THIS IS NOT A LIFESAVING DEVICE
•UsersmustwearaCoastGuardApprovedpersonalflotationdevice(PFD)atalltimes.
•ExamineeachD‐ringaftereachuse,andrepairitiftherearesignsofwear.
FLOATING DECK USE AND CARE WEATHER CONDITIONS AND LOCATION
•Observe Coast Guard rules and regulations when using this product.
•Do not use this product in offshore wind conditions.
•Do not use this product in more than 10 knots of wind. Windy conditions may result in serious
injury or death.
•Caution should be used when carrying this product. Carrying the deck in windy conditions may
result in serious injury to the users and other nearby.
•Do not use this product in thunderstorms and lightning conditions.
•Do not use the product in conditions that are beyond the user’s ability (examples, but not limited
to high surf, riptides, currents, or river rapids).
•Do not use this product near other boat traffic, or watercrafts.
•The US Coast Guard has ruled that any large floatation device used outside of the "surf zone" is
considered a watercraft. As such when in flat-water streams, lakes, rivers, bays, etc. you must
have a USCG approved Life Preserver (PFD) onboard your Deck for each passenger. This
"Rule" is being enforced by State and Local authorities nationwide as well. Additionally,
ALWAYS WEAR A Personal Flotation Device when using this Deck.

4
CARTON CONTENTS:
As you open the carton, make sure the following are inside:
•Pump with pressure gauge
•Repair kit
INFLATION PROCEDURE:
1. Choose a smooth surface to assemble your Floating Deck.
2. Remove the Deck from the box and unroll it.
3. Attach pressure gauge to hose and then attach pressure gauge to pump.
4. Attach other end of hose to the inflation/deflation valve on the rear of the board as shown below.

5
5. Stand the pump on hard, level ground and start to pump. The first time you inflate the Floating
Deck will require more effort than subsequent inflations.
6. Make sure you keep your hands toward the center of the pump handles when pumping and your
feet firmly on the footrests of pump.
7. Pump time varies by user but normally takes 12 to 15 minutes.
8. Adaptors to high volume pumps available for quicker inflation.
We recommend using the Floating Deck at a pressure between 12 - 15 psi. 15 psi gives you the
best performance. The final few PSI is the key to getting the maximum performance from your
board
WARNING: DO NOT USE AN AIR COMPRESSOR. It will result in damage to the
board, and will void all warranties. Maximum air pressure for this product is 15psi. DO NOT
INFLATE BEYOND 15PSI. Inflatable SUP boards are not warranted against over inflation.
DEFLATION PROCEDURE:
1. When you are ready to deflate your Floating Deck, unscrew the valve cover, gently push down
the central valve head.
2. Once the main pressure has decreased, push down all the way and twist the valve head. This
will lock the valve open and allow all air to escape from the board while you roll it up for storage.
3. Clean and check the board as well as all the accessories. Make sure the board is completely
dry before putting it away. Make sure that no sand or gravel remains inside the Floating Deck or
between the hull and the inner chambers. This could result in abrasion or even punctures while
storing the Floating Deck.
NOTE: If you leave your Floating Deck exposed to the hot sun, check the pressure and deflate it
slightly. The board may become over inflated and stretch the material. The ambient temperature
affects the tube’s internal pressure; a variation of 1.8 degrees Fahrenheit (1°C) causes a variation of
the pressure in the tube of +/- 0.06psi (4mbBar)

6
REPAIRING SMALL PUNCTURES:
A repair kit comes with your Floating Deck. It contains repair fabric, adhesive and a valve wrench.
To make a repair, follow these steps:
1. Cut your patch to extend 2” beyond all edges of the tear. Round the corners of the patch.
Square corners are more likely to snag and lead to peeling.
2. Trace the outline of the patch on the damaged surface with a pencil.
3. Clean the surfaces.
4. Apply two even, thin coats of the adhesive provided to both surfaces. Allow the adhesive to dry
5-10 minutes, to the “tacky” not wet, stage.
5. When both of the surfaces are still tacky, you are ready to complete the patch.
6. This is a contact adhesive and once the surfaces touch you cannot reposition the patch, so
carefully align it before bonding the two surfaces together.
7. “Roll” the patch onto the board surface to prevent trapping air under the patch.
8. Thoroughly go over the surface of the patch with a roller, edge of the valve wrench or other
implement, to apply pressure and ensure a solid bond.
9. Complete curing of the bond will take approximately 24 hours. Do not put air pressure in the
chamber before that time.
WARNING:
•Performallofyourrepairsinawellventilatedarea.
•Avoidinhalingtoxicvapors.
•Avoidcontactwithadhesive.
•Keepallrepairmaterials(glue,solvents,etc.)awayfromthereachofchildren.
STORAGE AND DECK CARE:
This board is manufactured with UV Resistant PVC to provide superior protection from ultraviolet
light. However, to ensure extra years of flexibility and bright colors, avoid storing the board where it
will be exposed to weather or in direct sunlight. Please review the following list for storage and
board care tips.
1. Before storing, hose off the Floating Deck and let it dry completely to prevent mildew buildup.
Do not use harsh chemicals for cleaning. Most dirt can be removed with a mild soap and fresh
water.
2. Do not store in extreme conditions (above 150F or below -10F). Store in a clean dry place.
3. When storing the board for prolonged periods in a deflated status it is best to keep it loosely
rolled, or if possible unroll it completely. Do not leave the Floating Deck in direct sunlight as this
may cause fading over a prolonged period.
Your new Floating Deck is made from durable PVC. If a tear or puncture does occur, PVC is easy to
repair. Repairs are easily done with your included patch kit. Read the following paragraphs for leak
detection and repair tips.

7
AIR LEAK DETECTION:
1. If you are losing air pressure, not caused by colder temperatures, check the board for leaks,
staring with the valves. A leaking valve is rare, but if you do find a leak a replacement valve is
available to order.
2. To locate a leak, we recommend a mixing of soap and water in a spray bottle. Spray around the
valve. If you see bubbles forming, check your valve seating and base and be sure the valve
insert is screwed tight.
3. If you can continue to have problems, it is probably time to order a new valve. Contact
Customer Service for a replacement.
WARRANTY INFORMATION:
Blue Water warrants this product to be free from major defects in material or workmanship to the
original purchaser for a period of one (1) year from the date of the purchase. This warranty is
subject to the following limitations:
1. The warranty is valid only when this product is used for normal recreational activities and does
not cover products used in rental or school operations.
2. Blue Water Toys will make the final warranty determination, which may require inspection.
3. If a product is deemed to be defective by Blue Water, the warranty covers the repair or
replacement of the defective product only. Blue Water Toys will not be responsible for any
costs, losses, or damages incurred as a result of loss or use of the product.
4. The warranty does not cover damage caused by improper use.
5. This product must not be modified and/or fitted with a motor.
6. This product must not be used in excess of the manufacturer’s recommended maximum load
capacity.
7. This warranty is void if any unauthorized repair, change or modifications has been made to any
part of the equipment.
8. The warranty of any repaired or replacement equipment is good from the date of the original
purchase only.
9. The original purchase receipt must accompany all warranty claims. The name of the retailer and
date of purchase must clear and legible.
10. There are no warranties that extend beyond the warranty specified.
This product is designed in accordance with standards for a specific use. Any modifications to the
product will void the warranty and could result in serious risks for the user.
For replacement parts and technical questions, please call 1-952-953-6140.
WARRANTY
One-year limited parts warranty
This manual suits for next models
3
Table of contents