BlueHive 035-7330-0 User manual

10 W 3-in-1 Wireless Charging Mount
User manual
This charging mount allows you enjoy fast wireless charging easily. Please
read the user manual before using and keep it for future reference.
Specifications:
Input: DC 5 V 2A, 9 V/1.67 A
Output: 10 W/7.5 W/5 W
Frequency: 110–205 kHz
Charge efficiency: ≥70%
Charging distance: ≤8 mm
Model No. 035-7330-0
Installation instructions:
a: Vent mounting
1. Loosen the socket on the back of the charging mount. Firmly snap in the
ball and tighten the socket.
2. Snap the clamp onto the air vent and adjust to your preferred viewing angle.

b: Windshield mounting
1. Clean the windshield where the suction cup will be applied.
2. Loosen the socket on the back of the charging mount. Firmly snap in the
ball and tighten the socket.
3. Push suction cup firmly against windshield and press lever to lock in place.
b: Dashboard mounting
1. Clean the dashboard where the disc will be applied.
2. Apply the holder to the disc, then remove adhesive backing from the bottom
of disc.
3. Use adhesive tape to mount the disc to the dashboard.

Connecting to power supply:
1. Connect USB 2.0 port to the car charger, and micro USB port to the wireless
car charger.
2. The LED indicator will turn to red, entering into standby mode.
Wireless Charging function:
1. Make sure the mount is connected to a power supply, and is in standby
status.
2. Press the release button to open the clamp. Place the phone inside the
mount, close the clamp to lock the device with your finger. The indicator
light will turn to blue and start charging.
Note: To activate fast wireless charging mode, please use QC 2.0/QC 3.0
car charger. You are recommended to use the USB cable featured in product
package.

Warning:
1. Do not squeeze or collisions.
2. Do not disassemble or throw into fire or water to avoid causing short circuit
leakage.
3. Do not use wireless charger in hot, humid or corrosive environments to
avoid damage.
4. Do not place wireless charger close to magnetic stripe or chip card(ID card,
bank card, etc.) to avoid magnetic failure.
5. Please keep the wireless charger at least 20 cm (7 7/8") from the
implantable medical devices (heart pacemakers, implantable cochlea, etc.)
to avoid potential interference of the medical devices.
6. It is normal for the product to be warm after charging. Charging in high
temperatures will reduce the charging efficiency. Charge in cool temperatures.
Made in China
Imported by Trileaf Distribution Toronto, Canada M4S 2B8
Product must be recycled or disposed of properly. Dispose of as per
the requirements of your local municipality
The ‘Qi ’ symbol is a trademark of the Wireless Power Consortium.
®
Note: If the phone case is metal, please take off the phone case before
charging. Do not use phone cases thicker than 5 mm (3/16") for wireless
charging.