Blumax Speech 001 User manual

Blumax Speech 001
User Manual
DeEn

- 2 -
- 3 -
Contents
EN
Inhalt
I. Prole and Its Function.............................................................................................. 4
I-1. Prole ..................................................................................................................... 4
I-2. Function.................................................................................................................. 5
II. How to use................................................................................................................ 7
II-1. Charge the Batteries ............................................................................................. 8
II-2. Turn on the Blumax Speech 001........................................................................... 8
II-3. Pair the Blumax Speech 001 with your Bluetooth Mobile Phone .......................... 9
II-4. Establish Bluetooth Link ....................................................................................... 11
II-5. Clip the Blumax Speech 001 onto Your Sun Visor ................................................ 12
II-6. Answer an Incoming Call....................................................................................... 12
II-7. Transfer Calls between This Blumax Speech 001 and Your Bluetooth Phone...... 12
II-8. Make a New Call by using Voice Dialing............................................................... 13
II-9. Answer the call waiting.......................................................................................... 14
II-10. Mute the Microphone........................................................................................... 14

- 2 -
- 3 -
EN
II-11. End a Call............................................................................................................ 15
II-12. Reject a Call ....................................................................................................... 15
II-13. Redial Last Dialed Number ................................................................................ 15
II-14. Adjust the Speaker Volume ................................................................................ 16
II-15. Recharge the Low Batteries ............................................................................... 16
II-16. Turn off the Blumax Speech 001......................................................................... 17
II-17. Auto connection to the Bluetooth Mobile Phone ................................................. 18
II-18. Auto power off ..................................................................................................... 18
III. Maintenance and Safe Use ..................................................................................... 19
IV. Electrical Power Specication (car charger/AC adaptor) ........................................ 19
V. Package Contents .................................................................................................... 20

- 4 -
- 5 -
I. Profile and Its Function
I-1. Profile
Fig.1
1. Volume Down
2. Volume Up
3. DC Socket
4. Microphone
5. LED
6. On/Off
7. Speaker
8. Visor Clip
9. Battery Door
EN

- 4 -
- 5 -
I-2. Function (please refer to Fig.1)
I-2-1. On/Off
If you press “On/Off ”, you can:
- Switch on and Off
- Pair
- Answer a new call
- Reject a call
- Make a new call using voice dialing
I-2-2. Volume Up
- Increase the speaker volume
- To mute/un-mute the microphone
I-2-3. Volume Down
- Redial the last dialed number
- Decrease the speaker volume
- Answer call waiting
I-2-4. LED
There are two LED colors (blue and
red) to indicate the state of this Car-
Kit.
EN

- 6 -
- 7 -
I-2-5. DC Socket
It serves as a recharging power socket for rechargeable batteries or
supplies the power to the Blumax Speech 001 when the car charger is connected
to your car.
I-2-6. Built-in Microphone
It allows you to communicate with good voice quality.
I-2-7. Speaker
I-2-8. Battery Door
Loading and unloading rechargeable batteries by opening the battery door.
I-2-9. Visor Clip
Clip the Blumax Speech 001 under your car’s sun visor.
EN

- 6 -
- 7 -
II. How to use
Fig.2
EN

- 8 -
- 9 -
II-1. Charge the Batteries (please refer to Fig.2)
Thank you for buying the Bluetooth Blumax Speech 001.
Before you use it for the rst time, please charge the batteries for 6 hours.
After this, you can fully charge the batteries in 4 hours.
Warning: Use only rechargeable batteries.
II-2. Turn on the Blumax Speech 001
If the Blumax Speech 001 is powered off, press and hold “On/Off ” for 2 seconds.
A long tone will indicate that the Blumax Speech 001 has turned on. At the same
time, the blue LED will ash for a second. And then, the blue LED will keep on ash-
ing every 3 seconds.
EN

- 8 -
- 9 -
II-3. Pair the Blumax Speech 001 with your Bluetooth
Mobile Phone
II-3-1. Put the Blumax Speech 001 in pairing mode
When the Blumax Speech 001 is powered off, press and hold “On/Off ” for 5 sec. In
the rst 2 seconds, a long tone will indicate that the Blumax Speech 001 has turned
on. At the same time, the blue LED will ash for a second. At the end of the 5 sec-
onds, a double tone will be heard. Then the red and blue LEDs will ash alternately,
which indicates the Blumax Speech 001 has entered into pairing mode.
Note: Make Sure the batteries are fully charged.
II-3-2. Put your Bluetooth Mobile Phone in pairing mode
II-3-2-1. Follow the operation manual of your Bluetooth mobile phone to start the
pairing process. Typically, this has to be done by going to a setup or connect menu
EN

- 10 -
- 11 -
and then selecting the options to show Bluetooth devices. Bluetooth may take sev-
eral seconds to establish a connection.
II-3-2-2. Your phone‘s display will indicate that it has found the new device “BLUMAX
SPEECH 001 ”. When you want to pair it, the phone‘s display would demand a
passkey or PIN, then you can enter a sequence of “0000”.
II-3-3. Pair the Blumax Speech 001 with your Bluetooth Mobile Phone
The blue LED of the Blumax Speech 001 will ash every 2 seconds indicating
successful pairing. The phone may also ask whether you want to change the
Blumax Speech 001‘s name. We recommend you should keep the name “BLUMAX
SPEECH 001” so please do not change it.
Note: If pairing does not occur as expected, turn off the Blumax Speech 001 and
your phone, then wait for 10 seconds. Turn them on again and repeat from Step
3-1 to Step3-3.
EN

- 10 -
- 11 -
II-4. Establish Bluetooth Link
After pairing, the mobile phone should show a “connect” menu. Please select it
to establish the link. A beep tone will indicate that the Blumax Speech 001 is con-
nected. You are now ready to make and answer calls on the Blumax Speech 001.
The Blumax Speech 001 is able to connect to 2 mobile phones at the same time.
To connect two mobile phones:
1. Pair with mobile phone 1 (steps II-3-1 to II-3-3 );
2. Pair with mobile phone 2 (steps II-3-1 to II-3-3 );
3. Connect mobile phone 1 ( steps II-4 );
4. Connect mobile phone 2 ( steps II-4 ).
It will operate with the last connected or activated mobile phone and automatically
switch between them.
Note: While connecting the Blumax Speech 001 to a mobile phone, do not use it
with another phone.
EN

- 12 -
- 13 -
II-5. Clip the Blumax Speech 001 onto Your Sun Visor (Fig. 3)
Fig.3
II-6. Answer an Incoming Call
When an incoming call is present, the
Blumax Speech 001 will ring. Press
“On/Off” and you can answer the call.
The blue LED will continue to ash
once a second while the call is in ses-
sion.
II-7. Transfer Calls between This Blumax Speech 001 and Your
Bluetooth Phone
When you are in session, calls can be transferred from your Bluetooth phone to the
Blumax Speech 001 and vice versa.
EN

- 12 -
- 13 -
II-7-1. From the Bluetooth phone to the Blumax Speech 001
Press “On/Off ” once, the call will be transferred to the Blumax Speech 001.
II-7-2. From the Blumax Speech 001 to the Bluetooth Phone
Please follow the operation manual of your phone.
II-8. Make a New Call by using Voice Dialing
II-8-1. When using a Bluetooth Mobile Phone:
II-8-1-1. Press “On/Off ” on the Blumax Speech 001 shortly when the Blumax
Speech 001 is in standby mode.
Note: Make sure that the voice dialing function is properly set up in the mobile
phone and it is within the range of the Blumax Speech 001 .
II-8-1-2. Put through the call
After the beep tone on the Blumax Speech 001, you can make a voice dial by say-
EN

- 14 -
- 15 -
ing the name of the person on the Blumax Speech 001. The call will be connected
in a few seconds.
II-9. Answer the call waiting
If during the active call in session another call is coming, pressing “Volume Down”
for 2 seconds will make the mobile phone to switch to the waiting call and place
the active call on hold. Press “Volume Down” for 2 seconds again, the mobile
phone will come back to the rst active call.
II-10. Mute the Microphone
II-10-1. To mute a call
Press “Volume Up” for 2 seconds and a beep tone will indicate that the microphone
is muted. A periodic reminder tone will be heard while the mute function is active.
EN

- 14 -
- 15 -
II-10-2. To un-mute a call
When the microphone is muted, press “Volume Up” for 2 seconds. Then the mute
function is deactivated and the periodic reminder tone will stop.
II-11. End a Call
While a call is in session on the Blumax Speech 001 , press “On/Off ” and you will
disconnect the call. A long tone will indicate that the call has ended. After the call is
disconnected, the blue LED will ash normally.
II-12. Reject a Call
When the Blumax Speech 001 is ringing, press “On/Off” for 2 seconds. Ringing will
stop and a long tone will indicate that the call is rejected.
II-13. Redial Last Dialed Number
To redial the last dialed number, press “Volume Down” for 2 seconds when the
Speech 001 is in standby mode. A beep tone will indicate an attempt to redial.
EN

- 16 -
- 17 -
II-14. Adjust the Speaker Volume
While a call is in session, pressing and releasing “Volume Up” will increase the speak-
er volume, and pressing and releasing “Volume Down” will decrease the speaker
volume. A double tone will be heard whenever the volume limit is reached.
II-15. Recharge the Low Batteries
(please refer to Fig.2)
The LED of this Blumax Speech 001 will ash red instead of blue when the battery
is low. There will also be a tone every 2 minutes. Please connect the charger cable
to the Blumax Speech 001 .
II-15-1. During recharging
The LED shows a steady red light if the Blumax Speech 001 is off,
and the red light will dim once every 3 second while the Blumax Speech 001 is on.
EN

- 16 -
- 17 -
II-15-2. Fully charged
A steady blue LED represents the Blumax Speech 001 is off and fully charged.
And a blue LED dims once every 3 seconds while the Blumax Speech 001 is on
and fully charged.
Note: When the battery level is too low, the Blumax Speech 001 will automati-
cally power off. It cannot be powered on again unless the batteries are sufciently
charged.
II-16. Turn off the Blumax Speech 001
When the Blumax Speech 001 is on, press and hold “On/Off ” for 5 seconds. A long
tone will indicate that the Blumax Speech 001 starts to power off. The LED contin-
ues to ash for a few seconds. At last the LED will turn off and the Blumax Speech
001 is powered off.
EN

- 18 -
- 19 -
II-17. Auto connection to the Bluetooth Mobile Phone
The Blumax Speech 001 has already been paired with a Bluetooth mobile phone. If
it is turned off and turned on again, it will search for an available Bluetooth link. If the
previously paired mobile phone’s Bluetooth feature is on, the Blumax Speech 001
and the mobile phone will re-establish the Bluetooth link automatically.
II-18. Auto power off
In order to save power, the Blumax Speech 001 will turn off automatically after it is
disconnected from the Bluetooth link for an hour.
EN

- 18 -
- 19 -
III. Maintenance and Safe Use
IV. Electrical Power Specification (car charger/AC adaptor)
- Use dry cloth to clean the Blumax Speech 001!
- Recycle the batteries after their life time!
- Do not expose the Blumax Speech 001 to liquid or moisture!
- Do not expose the Blumax Speech 001 to re or open ames!
The electrical power specication of car charger / AC adaptor for Bluetooth
Blumax Speech 001 is as follows:
- Input: 11-24VDC
- Output: 5V---1,0A
EN

- 20 -
- 21 -
V. Package Contents
ACCESSORIES STATUS
1 x Car Charger Provided
3 x AAA Rechargeable
Batteries Provided
Warnung: use only rechargeable batteries.
EN