BodyBilt ErgoGenesis GX7 Gaming Chair User manual

ErgoGenesis Workplace Solutions, LLC
Manufacturer of BodyBilt Seating
& Ergonomic Workplace Solutions
W: www.BodyBilt.com
P: 800.364.5299
E: Customer-[email protected]
GX7 Gaming Chair
Instructions
E-Mechanism

GX7 Gaming Chair Instructions
Back Height
Grasp the bottom of the chair back and lift to the desired
height. If the back is too high, lift the back to the highest
position to return to the lowest position, then re-adjust
the height.
Neckroll Adjustment
Turn the knobs on the neckroll pivot point forward to
release the neckroll. Grasp the neckroll pillow and move
to the desired height and angle. Turn the knobs rearward
to lock the neckroll into position.
Air Lumbar
Press the Air Lumbar bulb in order to increase the
lumbar support on your chair. Push on the button at the
top of the Air Lumbar bulb to release the air, reducing
the lumbar support.
Armrest Adjustments
Height: Lift and hold the trigger on the side of the arm
to adjust arm height. Release trigger to set the height.
360° Rotation: Grasp both ends of the arm pad, then
lift and rotate to the desired angle. Pivot: Twist front of
the arm pad to the left or to the right up to 30°.
Armrest Width
Loosen the armrest knob under the seat and slide the
armrest in or out. Tighten the knob to lock at the desired
width. For additional width increase and decrease, slide
the arm pad inward or outward to the desired position.
Back Angle
From a seated position, lift and hold the third lever from
the front on the right side of the chair. Lean on the chair
back to place it in the desired position. Release the
lever to lock the back into place.
Seat Height
Without weight on the seat, raise the second lever from
the front. Raise or lower the seat to the desired position,
then release the lever to lock the seat height into place.
Seat Tilt
While seated, raise the first lever from the front to
release the seat. This will allow for a smooth rocking
motion pivoting from the knee. Lower the lever to lock
the seat tilt into desired position.
Casters
Made for easy movement, the casters are compatible
with hard floor or carpet environments.
Tension Control
Turn the circular tension control knob under the center
front of the chair to the right to tighten and increase the
firmness of the rocking motion. Turn the knob to the left
to decrease the firmness.
Seat Depth
Lift seat slide lever and hold. Move the seat forward or
backward to the desired depth then release the seat
slide lever to set.