BOERPLAY SOLE030.099 User manual

SOLE030.099
Toddler seat swing

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE SOL 030 099 A
Miniswoeng
Peuterzitje
3-4-2014
BOER
SPEELTOESTELLEN
Afmetingen Dimensions
1,65 m
0,35m
0,00 m
1,40 m
1,61 m
>0,40m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE SOL 030 099 A
Miniswoeng
Peuterzitje
3-4-2014
BOER
SPEELTOESTELLEN
Obstakelvrije zone Obstacle free zone
Obstakelvrij WAS
Obstacle free WAS
Opvangzone
Impact area
Obstakelvrij EN-1176
Obstacle free EN-1176
1,75 m
6,24m
1,00m
2,75 m
4,65 m
R1,50m

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE SOL 030 099 A
Miniswoeng
Peuterzitje
3-4-2014
BOER
SPEELTOESTELLEN
Bodemplan Groundplan
0,65m
3,26m
2,91m
0,50m
o

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
TOE SOL 030 099 A
Miniswoeng
Peuterzitje
3-4-2014
BOER
SPEELTOESTELLEN
odules odules
OpmerkingBenamingRev.Bew.VolgnrProgr.Type
#
Nr
UkkepukSchommel
B177TUKPMOD11
1
Geleverde modules:
Zie tabel
Montageinstructie:
- De hoofdmaten geven de maten van de staanders en vloeren aan
- De detailtekeningen geven specifiek de maten van de verbindingen aan
- De modules met bui en ijn op de tekeningen bemaat op bovenkant kopplaat
- Overige modules ijn bemaat op de bovenkant (klimwanden, paalkappen, etc.)
Montagevolgorde:
1 - Graaf de gaten volgens het bodemplan
2 - Plaats 1
3 - Controleer of het toestel voldoet aan de afmetingen oals op blad 'afmetingen'
4 - Dicht de gaten en verdicht het and
Controles:
1 - Correcte opbouw en alle bevestigingsmiddelen
2 - Controleer de afmetingen van de valbodem t.o.v. het toestel°
Supplied modules:
See table
Assembly instruction:
- The main dimensions indicate the dimensions of the posts and floors
- The detailed dimensions show the specific dimensions of the connections
- The modules which contain tubes are dimensioned at the top of the flanges
- Other modules are dimensioned at the top (climbing walls, caps for the posts, etc.)
Assembly sequence:
1 - Dig the holes according to the ground plan
2 - Place 1
3 - Check that the equipment conforms to the dimensions shown on sheet 'dimensions'
4 - Close the holes and compact the sand
Checks:
1 - Correct assembly and all the fasteners
2 - Check the dimensions of the safety area with regard to the play equipment

LOGBOOK
(Onderstaand logboek kan gebruikt worden om te voldoen aan de eisen, gesteld in artikel 14 van het Warenwetbesluit Attractie- en Speeltoestellen)
Type indication Toddler Play
Product code SOLE030.099
Name of equipment Miniswoeng hardhout met peuter
Maximum height of fall 0,9 m
Year of construction 2017
Certificate 09100313232
inspection authority Liftinstituut B.V.
Buikslotermeerplein 381, A'dam - 1025 XE Amsterdam
Name manufacturer BOERplay
Hyacintstraat 2 - 4255 HX Nieuwendijk
Phone: [phone]
Fax: [phone]
name installer
Description of equipment Toddler seat swing
Location of equipment
Data about the owner of the play equipment
Name:
Address:
Postcode and town:
Contact person:
Telephone number:
Data about the administrator of the play equipment
Name:
Address:
Postcode and town:
Contact person:
Telephone number:
SOLE030.099
Toddler seat swing

LOGBOOK
Inspection and maintenance intervals
Nr.
Inspection Maintenance
months
between
inspections
1
Verify equipment's stability, junctions and missing parts.
Inspect bolts, screws and nuts for absence, jams, corrosion
and wear.
Add missing parts, secure joints, apply missing fixing
agent and replace corroded parts.
1
2
Chec suspension for wear. Replace worn parts and/or remove non-functioning
parts.
1
3
Inspect rotating parts such as hinges, rolling-element
bearings, etc. for wear and acceptability.
Replace worn parts and/or remove non-functioning
parts.
1
4
Chec wood for splinters, unacceptable damage and signs of
rot. Especially at ground level.
Repair damage. Replace affected wood. Smoothen
splintered wood and sharp edges.
1
5
Inspect foundation for stability, tearing and coverage. Restore foundation and covering material.
3
6
Examine rubber and synthetic parts for wear, damage and
brea . Replace original parts.
3
7
Inspect metal for corrosion and damage in the coating. Restore any damaged coating (after removing rust and
applying primer).
6
Chec ropes, cables, chains and nets for wear and damage.
Steel cables and nets which are tensioned must be chec ed
for tension.
Replace parts where necessary. Steel cables and nets
must be tensioned.
3
9
Inspect equipment for unsafe changes and additions. Remove unsafe additions and correct unsafe changes.
1
10
Inspect safety surfaces. Restore and repair where necessary.
1
Remarks
1. If used intensively, all points require extra attention.
2. Extreme weather conditions and locations may require a higher inspection frequency. Discuss this with
the supplier.
3. Vandalism-sensitive locations require stricter inspections, possibly daily.
4. Check the terrain regularly for items that do not belong there, are unsafe or may be used wrongly.
Examples are poisonous plants, glass shards, etc. Frequency depends on strain.
5. Remember that bad maintenance leads to unsafe conditions and notably faster impoverishment of the
playground area.
6. Replacement parts can be ordered at the manufacturer with the part numbers on the module drawing.
Drawings can be found in de user guide.
7. The impact area shall be provided with impact attenuating surface according to the specified falling
height.
. This list is conform the CEN-standard "playground equipment and surfacing NEN-EN 1176-7".

Benaming
Title
Opmerking
Comment
Datum
Date
Tekening
Drawing
MOD UKP HHT 177 B
Schommel
Ukkepuk
6-12-2013
BOER
SPEELTOESTELLEN
Samenstelling module Assembly module
Opmerking
BenamingRev.Bew.
Volgnr
Progr.Type#Nr
5 x 50SCHROEF 050005002BSR21
M10 - RVS A2-70
Bo gdopmoe
020010011BSR62
M10 x 110 - RVS A2-70
Zeskantbout
110010021BSR63
M10 x 16 - RVS A2-70
Bolkopbout ISO 7380
016010023BSR24
M10SLUITRING 002010030BSR12
5
5 mm, RVS A2-70
D-Sluiting
000005031BSR26
M10 - VZ 8.8
Bo gmoe
010010010BSV
47
M10 x 100 - VZ 8.8Zeskantbout ISO 4014 100010021BSV
4
8
Peute zitje
Peute schommel
A
001HUC
DRD
19
Donut RoodBesche mdop M10-M12
030010DONKST610
6 MM ROODOPVULDOPJE 030006DOPKST211
Dop oodBesche mdop M10-M12
030010DOPKST612
KUNSTSTOFRING 008005RNGKST213
M10 x 2.5 MMRING NYLON 000010RORKST1414
Igus
Glijlage
048025IGSLAG415
UkkepukStaande schommel
HHT127UKPOHO216
Zamak, Ral 5003
PAALKAP 80 ZMK080KAPOME217
UkkepukEindplaat schommelas
320561
UKP
OME218
UkkepukSchommelkop Oh
B
030032
UKP
OPE219
UkkepukSchommelas
B
320558
UKP
SME220
UkkepukLoopdeel scha nieC320559
UKP
SME221
Ext a zwaa
G ondanke
372616
VRB
SME222
16
1
17
19
2
5
14
14
12
3
5
10
11 4 14 18 15 21 15 20
9
22
7
8
6 13