Bomma LANTERN User manual

A, Introduction
• Before you go in any manipulation with the appliance,
please read carefully this direction, and observe all instructions
and recommendations!
• The lighting assembly must be made with more persons
than one.
• It is forbidden to use the product for the purpose other than
intended, and contrary to this direction, and that for safety
reasons and for the reason of the guarantee termination.
• Switch off power at main circuit panel prior to installation!
• Any electric installation, including putting the appliance into
operation, may be performed by a qualified electrician only.
• Prevent children and persons with lowered sensual and
mental capabilities to manipulate with the lighting fitting since
the product consists of tiny and fragile components that may
be dangerous for them at manipulation or in case of ingestion.
• The manufacturer assumes no liability for damage resulting
from incorrect installation.
• The pendant light is intended for the illumination of interior
or home accommodation.
B, Product name: Table lamp LANTERN
• The table lamp LANTERN is available in one size in dimensi-
ons as indicated below.
• The lamp shade is hand-blown from clear crystal material.
• The product is intended for the illumination of interior (dry
environment only).
C, Components included with unit
• Hand-blown crystal lamp shade
• Powder coating base fitting (available in black or white
colours)
• Installation Instructions, Letter of guarantee
• Cleaning and Maintenance Manual
• Gloves
Light source and fixing material are not part of the lighting
fixture kit.
D, Assembly and Disassembly -
connecting to and disconnecting from the
network
• After unpacking, first of all, check for damage during
the transport and for completeness. If anything is wrong,
contact your dealer immediately since later complaint for
the above reasons would not be accepted.
• Perform the assembly of the appliance with the use of
schematic drawing, respecting that the electric installati-
on and connection to the network may be performed by
an electrician with proper qualifications only, while
observing general regulations as well.
• Use the appropriate source on the bulb sleeve (1). In
order to put a new bulb into a lighting fixture’s socket,
turn the bulb in a clockwise direction.
• Insert the crystal part (2) to the bottom fitting (3).
• At disassembly, first switch the lighting fitting off, and
disconnect it from the power.
• Then you may proceed in a similar way, in the opposite
order than at the assembly.
• Any transport of the appliance later should be perfor-
med either in the original wrap or similar in order to avoid
damage.
• Technical support: [email protected]
TABLE LAMP
LANTERN
Ø 225 mm
415 mm 370 mm

E, Technical specification, purpose
• Nominal voltage: 230 V/ A.C. 50Hz
• Protection: IP 20
• Nominal input: 1x 40 W (E27)
• Class: II.
• Weight of crystal part: (approx.) 3,5 kg
Recommended energy - saving LED E27.
F, Liquidation
After the end of the technical life span of the appliance, before its
liquidation, disconnect it from the electric cord, dismount it and
separate the individual parts. The sorted out waste material
should be delivered to the organization authorized to liquidate
ID
10 11 11*
10 11 12
17 04 01
17 04 05
20 01 01
15 01 05
Category
N
O
O
O
O
O
Title
Small particles of waste
glass and glass powder
containing heavy
metals included PbO
Waste glass other than
no. 10 11 11 (sodium-
potassium glass)
Copper, bronze, brass
Iron and steel
Paper and pasteboard
Package with plastic insert
Bohemia Machine s.r.o.
Zámecká 1177
58291 Světlá nad Sázavou
Czech Republic
[phone]
[email protected]
www.bomma.cz
(2) crystal part
(1) bulb sleeve
(3) bottom fitting
pic. 1