BROKIS IVY BATTERY User manual

CM13578

IVY
Table light
1x light
1x LED light source
1x glass shade
1x USB-C charging cable
1x pair cotton gloves
1x installation manual
The manufacturer assumes no liability for
damage resulting from incorrect assembly.
When unpacking the light, do so with regard
for its composition – part of it is made of
glass.
The light must be charged prior to first use.
Wear the cotton gloves included with the light
when unpacking and assembling it.
INSTALLATION
MANUAL
COMPONENTS INCLUDED
WITH UNIT:
WARNING:
Installation time: 10 minutes / 1 person
BROKIS S.R.O.
ŠPANIELOVA 1315/25
163 00 PRAHA 6 - ŘEPY
CZECH REPUBLIC
ORG. ID 64940799
VAT ID CZ64940799
C 42174 MĚSTSKÝ SOUD
V PRAZE
TEL [phone]
[e-mail]
[e-mail]
WWW.BROKIS.CZ PAGE 2
Download

CLEANING THE GLASS:
BROKIS upholds only the highest possible quality standards. Prior to shipping, the light undergoes several
quality controls and stages of cleaning. Because transportation, storage, and the amount of time that passes
between packing at our plant and subsequent unpacking by the client can affect the light in different ways, we
strongly recommend cleaning it prior to assembly.
The glass must first be rinsed in warm water, and a dish detergent may be used to remove all foreign particles,
dust, and grease. Repeat the process if necessary and then dry the glass thoroughly with a paper towel.
Recommendation: Do not use mineral spirits, highly concentrated thinners, or other substances not intended for
use on glass surfaces. Do not use any cleaning agents containing silicone, as they may leave a film and attract
dust and smudges.
PRIOR TO SHIPPING, THE FUNCTIONALITY OF THE LIGHT AND ITS COMPONENTS ARE CHECKED THOROUGHLY.
THE MANUFACTURER ASSUMES NO LIABILITY FOR THE MISHANDLING OF PRODUCTS.
IVY
Table light
INSTALLATION
MANUAL
BROKIS S.R.O.
ŠPANIELOVA 1315/25
163 00 PRAHA 6 - ŘEPY
CZECH REPUBLIC
ORG. ID 64940799
VAT ID CZ64940799
C 42174 MĚSTSKÝ SOUD
V PRAZE
TEL [phone]
[e-mail]
[e-mail]
WWW.BROKIS.CZ PAGE 3
Cleaning information

Wear the cotton gloves supplied with the light when removing it from the packaging. Install the LED light source and screw
the glass shade onto the fixture.
ASSEMBLING THE LIGHT
1.
PAGE 4

To charge the light, plug the USB-C cable into the base.
Charging is indicated by a red LED. Charging is complete when the LED changes to green.
Time to full charge: 4 hours.
Battery life from full charge: 6 hours.
Recommended charging adapter: 5V / 2A max.
CHARGING THE LIGHT WITH THE USB-C CABLE
2.
PAGE 5

Switch on the light and verify that it works properly.
Touching any metal part of the light switches it on and also adjusts the brightness to one of three levels.
SWITCHING ON THE LIGHT
3.
PAGE 6

Place the light on the wireless charger.
Charging is indicated by a red LED. Charging is complete when the LED changes to green.
WIRELESS CHARGER NOT INLCUDED WITH LIGHT
CHARGING THE LIGHT VIA WIRELESS INDUCTION
4.
PAGE 7