Bondtech LGX Lite V2 User manual

QUICK START GUIDE
LGX® Lite V2 on the
Voron 0.2

Position 0
Load or unload filament
without pressure from
the drivegears
Page 2/5
LEVER POSITIONS
The different lever positions of the LGX lite V2 allows for flexibility when
using different kinds of filaments and for loading and unloading. Below we
have outlined the intended use of these different positions.
www.bondtech.se
Position 1
For rigid materials
Position 2
For semi-flexible or
flexible materials
QUICK START GUIDE
For the LGX® Lite V2 on the Voron 0.2

Page 3/5 www.bondtech.se
KLIPPER CONFIGURATION
For the LGX Lite V2 to work on the Voron 0.2 you need to
adjust a couple of settings regarding the extruder in your
Klipper configuration.
This is set in the [extruder] section in your cfg file
rotation_distance: 5.7
#gear_ratio: 1:1
This is set in [tmc****] section
run_current: 0.65
SLICER CONFIGURATION
When using the factory profiles, change the retraction
parameters. For larger nozzles than 0.40 mm you may need
to add length to this.
0.4mm nozzle 35 mm/s, 0.5 mm length
0.6mm nozzle 35 mm/s, 0.7 mm length
QUICK START GUIDE
For the LGX® Lite V2 on the Voron 0.2

Page 4/5 www.bondtech.se
QUICK START GUIDE
For the LGX® Lite V2 on the Voron 0.2
TAKE GOOD CARE OF IT
Every 6 months, or sooner if you have a higher than 15h per week average usage, perform the following maintenance operations:
1. With a tooth brush and alcohol:
a. Clean the needle bearings
2. With a fine brush and lubricant
a. Lubricate the needle bearings
3. With compressed air
a. Blow the housing plastic parts to remove dust and dirt particles
HOW TO GET HELP
We are available to help you with any questions or issues you may have. Simply go to our website where you can access our
customer support and send us your questions or follow the provided link:
https://www.bondtech.se/contact/#tab_technical-support-requests

www.bondtech.se