Bornoble BNKC-5737C0 User manual

Electric Food Warmer
Instruction Manual
This manual applies to Bornoble models:
BNKC-5737C0 BNKC-5737C0T
Ningbo Bornoble Catering Equipment Technology Co.,Ltd.
No.115 Xiwu South Road, Xiwu Street, Fenghua District,
Ningbo City, Zhejiang Province, P.R.China, 315500
TEL: [phone] E-mail: [e-mail]
Website: www.bornoble.com

2
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• Fire Precautions
• IEE Wiring Regulations
• Building Regulations
• DO NOT immerse the appliance in water, or use jet/pressure washers to clean it.
• DO NOT touch hot surfaces with bare hands. Always use the handles/protective gloves.
• DO NOT overfill the appliance. Keep the water level below the ‘MAX’ level.
• DO NOT allow the water level to drop below the ‘MIN’ level during operation.
• DO NOT move the appliance when it contains hot liquid.
• DO NOT use the appliance for anything other than its intended use.
• Always switch off and disconnect the power supply to the appliance when not in use.
• Not suitable for outdoor use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations
of local authorities.
• If the power cord is damaged, it must be replaced by an agent or a recommended qualified
technician in order to avoid a hazard.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this appliance will provide the best possible performance from your product.
Pack Contents
The following is included:
•Food Warmer
•Instruction Manual
On quality and service, it is ensuring that at the time of packaging the contents are supplied fully
functional and free of damage.
Should you find any damage as a result of transit, please contact your dealer immediately.

3
Note: we recommend that fresh water be used each time the appliance is used.
WARNING: Do not allow the water to drop below the ‘MIN’ level during operation.
Severe damage to the heating element could result.
Note: Always switch the appliance off allow the water to cool before emptying.
Note: Always switch off and disconnect the appliance from the power supply before
cleaning. Always allow the appliance to cool before emptying or cleaning.
Operation
1. Connect the appliance to the power supply.
2. Fill the tank with water to a level between the ‘MIN’ and ‘MAX’ marks on the inside of the tank.
3. Switch the rocker switch to the On position [I]. The rocker switch light will turn on.
4. Turn the thermostat to the desired temperature to heat-up the appliance.
5. Once the appliance has heated the water, the pilot light turns Off.
6. Reduce the heat setting on the thermostat to maintain temperature.
Maintaining Water Levels
It is important to regularly check the water level in the Food Warmer tank.
• Always keep the water level above the ‘MIN’ mark on the inside of the tank during operation.
• Damage to the heating element can occur if the tank boils dry and the element may have to be
replaced.
• This is not covered by the warranty.
Emptying the Appliance
BNKC-5737C0 - Use a suitable container to remove the water from the appliance.
BNKC-5737C0T - Turn on the tap to drain the water. Ensure a suitable container is used to collect the
water.
Cleaning, Care & Maintenance
• Wipe down the exterior of the appliance with a damp cloth.
• Some cleaning agents may cause damage when used for a prolonged period on stainless steel. Use a
suitable stainless steel cleaner.
• Dry the exterior thoroughly.
• Wash all removable parts in warm, soapy water.

4
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to the Helpline.
Technical Specifications
Warning
Electric Shock Hazard: Plug the device properly into a grounded electrical outlet, please check voltage
and plug type before plug in. If the plug and socket do not match, qualified electrician should install the
proper voltage electrical outlet.
Compliance
The parts have undergone strict product testing in order to comply with regulatory
standards and specifications set by international, independent, and federal authorities.
The products have been approved to carry the following symbol:
Fault
Probable Cause
Action
The unit is not working
The unit is not switched on
Check the unit is plugged in correctly
and switched on
Plug and lead are damaged
Call agent or qualified
technician
Fuse in the plug has blown
Replace the plug fuse
Power supply
Check power supply
Internal wiring fault
Call agent or qualified
technician
The thermostat has not been
set correctly
Set the thermostat to a higher
temperature
The heating element has failed
Call agent or qualified
technician
Model
Voltage
Power
Current
Dimensions
W x D x H
Net Weight
BNKC-
5737C0
120V
1200W
10A
14.57 x 22.56 x 9.65 IN
17.64 LBS
BNKC-
5737C0T
120V
1200W
10A
14.57 x 22.56 x 9.65 IN
18.74 LBS

5
Service and Warranty
This equipment is warranted to the original user against defects in workmanship or
material under normal use for One Year from the date of sales.
1. If there are defects within three days of sales (subject to customer's receipt of
the equipment), company will provide free return, replacement or repair service.
2. During the warranty period, company will provide free repair service to the original
equipment.
3. During the warranty period, company will provide replacement if there are
excessive repair records.
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of Bornoble .
Every effort is made to ensure all details are correct at the time of going to press, however, Bornoble reserve the
right to change specifications without notice.