BOSCARE CM9408T-UL User manual

BOSCARE
CM9408T-UL
Coffee Maker
BOSCARE

IMPORTANT SAFEGUARDS
When using electrical appliance. Basic safety precautions
should always be followed including the following:
1. Read all instructions.
2. Make sure that your outlet voltage corresponds to the
voltage stated on the rating label of the coffee maker.
3. To protect against fire, electric shock and injury to
persons do not immerse cord, plug, or in water or other
liquid.
4. Close supervision is necessary when any appliance is
used by or near children.
5. Unplug from outlet when not in use and before clean-
ing. Allow to cool before putting on or taking off parts, and
before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or has been
damaged in any manner. Return appliance to an autho-
rized service facility for examination, repair or adjustment.
7. The use of accessory not recommended by the
appliance manufacturer may result in fire, electric shock
or injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or
touch hot surface.
10. Do not place on or near a hot gas or electric burner,
or in a heated oven.
11. Do not use appliance for other than intended use.
12. Do not clean carafe with cleansers, steel wool pads,
or other abrasive material.
13. To disconnect, turn any control to “Off”, remove plug
from wall outlet. Always hold the plug. But never pull the
cord.
14. Scalding may occur if the cover is removed during the
brewing cycles. Be careful not to get burned by the
steam.
15. Some parts of appliance are hot when operated, so
do not touch with hand. Use handles or knobs only.
16. Do not set a hot carafe on a hot or cold surface.
17. Do not let the coffee maker operate without water.
18. Do not use a cracked carafe or a carafe having a
loose or weakened handle.
19. Please do not open the top cover and make sure the
glass carafe is placed on the thermal insulation plate
correctly during the brewing.
20. To reduce the risk of fire or electrical shock, do not
remove the cover. No user serviceable parts inside.
Repair should be done by authorized service personnel
only.
21. The carafe is designed for use with this appliance. It
must never be used on a range top.
22．This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
23. Children should be supervised to ensure that they do
not play with the appliance.
24. This appliance is intended to be used in household
and similar applications such as:
– staff kitchen areas in shops, offices and other working
environments;
– farm houses;
– by clients in hotels, motels and other residential type
environments;

– bed and breakfast type environments.
25.
Notes for cord plug:
This appliance has a polarized plug (one blade is
wider than the other). To reduce the risk of electric
shock, this plug is intended to fit into a polarized outlet
only one way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a qualified
electrician. Do not attempt to modify the plug in any way.
Notes for Power cord:
a)A short power-supply cord (or detachable power-sup-
ply cord) is provided to reduce risks resulting from
becoming entangled in or tripping over a longer cord.
b)Longer detachable power-supply cords or extension
cords are available and may be used if care is exercised
in their use.
c)If a long detachable power-supply cord or extension
cord is used:
1)The marked electrical rating of the detachable
power-supply cord or extension cord should be at least
as great as the electrical rating of the appliance;
2)If the appliance is of the grounded type, the extension
cord should be a groundingtype 3-wire cord; and
3)The longer cord should be arranged so that it will not
drape over the counter top or table top where it can be
pulled on by children or tripped over.
KNOW YOUR COFFEE MAKER
CONTROL PANEL
Filter
Funnel
Control panel
Carafe lid
Glass carafe
Top cover
Water level gauge
Main housing
Thermal insulation
plate
Bottom cover
LCD display
STENGTH indicator
Knob
ON/OFF
indicator
SAVE THESE INSTRUCTIONS
Household use only

Check that all accessories are complete and the unit is
not damaged. Fill water into water tank to the MAX level
and brew water for several times without coffee powder,
then discard the water. Clean and dry all detachable
parts thoroughly according to the section “CLEANING
AND MAINTENANCE” .
1.Open the top cover and fill the water tank with
drinking water. The water level should not exceed MAX
level as indicated on the water level gauge.
2.Place the funnel into the funnel support, make sure it
is assembled correctly, otherwise the top cover cannot
be closed. Place a filter or paper filter in the funnel.
3.Add coffee powder into the filter. Usually a cup of
coffee needs a level spoon of coffee powder, but you
may adjust according to personal taste. Close the top
cover completely.
4.Insert the glass carafe with lid closed onto the thermal
insulation plate horizontally.
5.Plug the power cord into the outlet, the LCD display
indicates “12:00” and it blinks.
6.Rotate the knob to set the current clock. Turn the
knob to the “HOUR” setting and then press the knob
once, one hour can be increased. And the “HOUR” can
be increased fast if hold and press the knob for more
than 1.5 seconds.
7.After setting the “HOUR”, turn the knob to the “MIN”
setting and then press the knob once, one minute can
be increased. And the “MINUTE” can be increased fast
if hold and press the knob for more than 1.5 seconds.
8.After finish setting the current clock, press the knob
once to confirm, then the clock starts to run.
9.Rotate the knob to the “ON/OFF” setting, then press
the knob once, the ON/OFF indicator illuminates in red,
and the coffee maker starts to brew normal coffee. If
you want to brew thick coffee, turn the knob to the
“STRENGTH” setting, the “STRENGTH” indicator
illuminates in orange, then turn the knob to the
“ON/OFF” setting and press the knob once, the ON/OFF
indicator will illuminate in red and the coffee maker will
brew thick coffee.
Note: To cancel the “STRENGTH” setting, turn the knob
to the “STRENGTH” setting and press the knob once.
10.The brewing process can be interrupted by pressing
the knob again at any time, and the ON/OFF indicator
will extinguish, indicating your coffee maker is shut off.
Note: You can take out carafe, pour and serve at any
time. The appliance will stop dripping automatically. But
the time cannot exceed 30 seconds.
11. Remove out carafe to serve when finish brewing
(about one minute later after the coffee stops dripping
out.)
Note: The coffee you get will less than the water you
have added, as some water is absorbed by coffee
ground and adhere to the plastic.
12. When the process is finished, if you do not want to
serve immediately, keep the coffee maker be energized,
BEFORE THE FIRST USE
USING YOUR COFFEE MAKER

If you do not want the coffee maker to start operation
immediately, for example now it is AM8:00, you hope that
the coffee maker will automatically start working at
PM1:00, first follow steps 1 to 5 of “USING YOUR
COFFEE MAKER”, and then you can set the automatic
start function as follows:
1. Follow the steps 6 to 7 of “USING YOUR COFFEE
MAKER” set the current time that is AM8:00.
Note: The time cycle is 12 hours.
2.Turn the knob to the “PROGRE” setting and then press
the knob once, the ON/OFF indicator blinks in green, and
the LCD display indicates AM“12:00” .
3.Follow the steps 6 to 7 of “USING YOUR COFFEE
MAKER” set the automatic start time that is PM1:00.
4.After setting the automatic start time, turn the knob to
the “PROGRE” setting and press the knob once, the
ON/OFF indicator illuminates in green solidly. After a
while, the LCD display indicates the current time.
Note: You may cancel the automatic start function by
turning the knob to the “PROGRE” setting and pressing
the knob once. If you want to change the automatic start
time, only following the above steps 2-3 again.
5. When the time is due, the ON/OFF indicator will
illuminate in red and the appliance starts brewing. When
the process is finished, if you do not want to serve
immediately, keep the coffee maker be energized, the
coffee can be kept warm on the warming plate. And the
appliance will shut off automatically after 120 minutes
from the ON/OFF setting being activated if it has not
been manually disconnected at the completion of
brewing. For an optimum coffee taste, serve it just after
brewing.
Note: During delay brewing process, the settings of
“HOUR” and “MINUTE” are invalid.
CAUTION: Be sure to unplug this appliance before
cleaning. To protect against electrical shock, do not
immerse cord, plug or unit in water or liquid. After each
use, always make sure plug is first removed from wall
outlet.
1. Clean all detachable parts after each use in hot sudsy
water.
2. Wipe the exterior surface of unit with a soft, damp
cloth to remove stains.
CLEANING AND MAINTENANCE
DELAY FUNCTION
the coffee can be kept warm on the thermal insulation
plate. And the appliance will shut off automatically after
120 minutes from the ON/OFF setting being activated if
it has not been manually disconnected at the completion
of brewing. For an optimum coffee taste, serve it just
after brewing.
13. Always turn the coffee maker off and disconnect the
power supply when not use.
Note: Pay attention to pour the coffee out, otherwise you
may be hurt as the temperature of coffee just finished is
high.

3. Water droplets may buildup in the above area of the
funnel and drip onto the product base during brewing. To
control the dripping, wipe off the area with a clean, dry
cloth after each use.
4. Use a damp cloth to gently wipe the thermal insulation
plate. Never use abrasive cleaner to clean it.
5. Replace all parts and keep for next use.
To keep your coffee maker operating efficiently, periodi-
cally you should clean away the mineral deposits left by
the water according to the water quality in your area and
the use frequency, we recommend removing mineral
deposits as follows:
1. Fill the water tank with water and descaler to the max
level as indicated on the water level gauge (the scale of
water and descaler is 4:1, the detail refers to the
instruction of descaler. Please use “household descaler”,
you may also use the citric acid instead of the descaler
(the one hundred parts of water and three parts of citric
acid).
2. Insert the glass carafe onto the warming plate.
3. Make ensure filter (without coffee powder) and funnel
are assembled in place.
4. Turn on the appliance and allow it to “brew” de-scaling
solution by follow the operation above.
5. After “brew” one-cup solution, switch off the appliance.
6. Leave the solution stay for 15 minutes and repeat step
3-5.
7. Turn on the appliance and run off the solution until
the water tank is completely empty.
8. Rinse by operating the appliance with water at least 3
times.
1. A clean coffee maker is essential for making
great-tasting coffee. Regularly clean the coffee maker
as specified in the “CLEANING AND MAINTENANCE”
section. Always use fresh, cold water in the coffee
maker.
2. Store unused coffee powder in a cool, dry place. After
opening a package of coffee powder, reseal it tightly
and store it in a refrigerator to maintain its freshness.
3. For an optimum coffee taste, buy whole coffee beans
and finely grind them just before brewing.
4. Do not reuse coffee powder since this will greatly
reduce the coffee’ flavor. Reheating coffee is not
recommended as coffee is at its peak flavor immediately
after brewing.
5. Clean the coffee maker when over-extraction causes
oiliness. Small oil droplets on the surface of brewed,
black coffee are due to the extraction of oil from the
coffee powder.
6.Oiliness may occur more frequently if heavily roasted
coffees are used.
REMOVING MINERAL DEPOSITS
HINTS FOR GREAT-TASTING COFFEE