BOSCARE CM1429TA-UL User manual

BOSCARE
CM1429TA-UL
Coffee Maker
BOSCARE

IMPORTANT
SAFEGUARDS
When using electrical appliance. Basic safety precautions
should always be followed including the following:
1. Read all instructions.
2. Make sure that your outlet voltage corresponds to the
voltage stated on the rating label of the coffee maker.
3. To protect against fire, electric shock and injury to
persons do not immerse cord, plug, or in water or other
liquid.
4. Close supervision is necessary when any appliance is
used by or near children.
5. Unplug from outlet when not in use and before
cleaning. Allow to cool before putting on or taking off
parts, and before cleaning the appliance.
6. Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or has been
damaged in any manner. Return appliance to an autho-
rized service facility for examination, repair or adjustment.
7. The use of accessory not recommended by the
appliance manufacturer may result in fire, electric shock
or injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or
touch hot surface.
10. Do not place on or near a hot gas or electric burner,
or in a heated oven.
11. Do not use appliance for other than intended use.
12. Do not clean container with cleansers, steel wool
pads, or other abrasive material.
13. To disconnect, turn any control to “Off”, remove plug
from wall outlet. Always hold the plug. But never pull the
cord.
14. Scalding may occur if the cover is removed during the
brewing cycles. Be careful not to get burned by the
steam.
15. Some parts of appliance are hot when operated, so
do not touch with hand. Use handles or knobs only.
16. Do not set a hot container on a hot or cold surface.
17. Never leave the empty carafe on the warming plate
otherwise the carafe is liable to crack.
18. Never use the appliance if the carafe shows any
signs of cracks or carafe having a loose or weakened
handle. Only use the carafe with this appliance. Use
carefully as the carafe is very fragile.
19. Do not let the coffee maker operate without water.
20. Appliances can be used by persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the appliance
in a safe way and they understand the hazards involved.
21. Close supervision is necessary when any appliance is
used by or near children.
22. To reduce the risk of fire or electrical shock, do not
remove the cover. No user serviceable parts inside.
Repair should be done by authorized service personnel
only.
23. The container is designed for use with this appliance.
It must never be used on a range top.
24. The appliance must not be immersed.

Notes on the cord plug
This appliance has a polarized plug, To reduce the risk of
electric shock, this plug is intended to fit into a polarized
outlet only one way, If the plug does not fit fully into the
outlet, reverse the plug, If it still does not fit, contact a
qualified electrician, Do not attempt to modify the plug in
any way.
Notes on the cord
a) A short power-supply cord (or detached power-supply
cord) is to be provided to reduce risks resulting from
becoming entangled in or tripping over a long cord.
b) Longer detachable power-supply cords or extension
cords are available and may be used if care is exercised
in their use.
c) If a long detachable power-supply cords or extension
cord is used,
1) The marked electrical rating of the detachable
power-supply cord or extension cord should be at least
as great as the electrical rating of the appliance.
2) If the appliance if of the grounded type, the extension
cord should be a grounding-type 3-wire cord,
3) The longer cord should be arranged so that it will not
drape over the counter top or table top where it can be
pulled on by children or tripped over.
KNOW YOUR COFFEE MAKER
CONTROL PANEL
Funnel
Control panel
Carafe lid
Carafe handleGlass carafe
Water tank lid
Water tank
Main housing
Warming plate
Bottom cover
Filter
Coffee spoon

Check that all accessories are complete and the unit is
not damaged. Fill water into water tank to the MAX level
and brew water for several times without coffee powder,
then discard the water. Clean and dry all detachable parts
thoroughly according to the section “CLEANING AND
MAINTENANCE”.
1. Open the water tank lid and fill the water tank with
drinking water. The water level should not exceed MAX
level as indicated on the water gauge.
2. Place the funnel into the funnel support, make sure it
is assembled correctly, otherwise the water tank lid can
not be closed. Place a paper filter in the funnel.
3. Add coffee powder into the paper filter. Usually a cup
of coffee needs a level spoon of coffee powder, but you
may adjust according to personal taste. Close the water
tank lid completely.
4. Insert the glass carafe onto the warming plate horizon-
tally.
5. Plug the power cord into the outlet. If you want to
adjust the coffee strength, you can press “Strength”
button once, and then the “Strength indicator” illuminates
in red and the appliance will brew thick coffee. If you do
not want to adjust the coffee strength, just follow the
following operation to brew normal coffee.
NOTE: Press the “Strength” button again if you want to
cancel the function of brewing thick coffee.
6.Press “On/Off” button, the “On/Off indicator” illuminates
in red, the display indicates “ 12:00” then the appliance
begins to work.
NOTE: During brewing process, the buttons of “Prog”
,“Hour” and “Min” are invalid.
7.The brewing process can be interrupted by pressing
the “On/Off” button at any time. And the appliance will
continue brewing once the “On/Off” button is pressed
again.
NOTE:You can take out the carafe, pour and serve at
any time. The appliance will stop dripping automatically.
But the time cannot exceed 30 seconds.
8. Remove out carafe to serve when finish brewing
(about one minute later after the coffee stops dripping
out.)
NOTE: The coffee you get will be less than the water you
have added, as some water is absorbed by coffee
ground.
9.When the process is finished, if you do not want to
serve immediately, keep the coffee maker be energized,
and the coffee can be kept warm on the warming plate.
And the appliance will shut off automatically after 2 hours
from the ON/OFF button being activated if it has not
been manually disconnected at the completion of
brewing. For an optimum coffee taste, serve it just after
brewing.
8.Always turn the appliance off and disconnect the power
supply when not use.
NOTE: Pay attention to pour the coffee out, otherwise
you may be hurt as the temperature of coffee just
finished is high.
BEFORE THE FIRST USE
USING YOUR COFFEE MAKER

If you do not want the coffee maker to start operation
immediately, for example now it is 8:10, you hope that the
coffee maker will automatically start working at 13:00 ,
first follow steps 1 to 5 of above section, and then you
can set the auto-start function as follows:
1. Set the current time by pressing “Hour” and “Min”
button repetitively, that is 8:10.
NOTE: The time cycle is 24 hours.
2. Press “Prog” button once and the “Program indicator”
blinks in white.
3. Set the auto-start time by pressing “Hour” and “Min”
button repetitively that is 13:00.
4. Press the “Prog” button again, the “Program indicator”
illuminates in white solidly. After a while, the display will
indicate the current clock.
NOTE: You may cancel the auto-start function by press-
ing “Prog” button again. If you want to change the
auto-start time, only following the above 2-4 steps again.
5. When the time is due, the On/Off indicator will
illuminate in red and the appliance starts brewing.
6. When the process is finished, if you do not want to
serve immediately, keep the coffee maker be energized,
and the coffee can be kept warm on the warming plate.
And the appliance will shut off automatically after 2 hours
from the On/Off button being activated if it has not been
manually disconnected at the completion of brewing. For
an optimum coffee taste, serve it just after brewing.
NOTE: During brewing process, the buttons of “Prog”
,“Hour” and “Min” are invalid.
CAUTION: Be sure to unplug this appliance before
cleaning. To protect against electrical shock, do not
immerse cord, plug or unit in water or liquid. After each
use, always make sure plug is first removed from wall
outlet.
1. Clean all detachable parts after each use in hot sudsy
water.
2. Wipe the exterior surface of unit with a soft, damp
cloth to remove stains.
3. Water droplets may buildup in the funnel and drip
onto the product base during brewing. To control the
dripping, wipe off the area with a clean, dry cloth after
each use.
4. Use a damp cloth to gently wipe the warming plate.
Never use abrasive cleaner to clean it.
5. Replace all parts and keep for next use.
CLEANING AND MAINTENANCE
DELAY FUNCTION

To keep your coffee maker operating efficiently, periodi-
cally you should clean away the mineral deposits left by
the water according to the water quality in your area and
the use frequency, we recommend removing mineral
deposits as follows:
1. Fill the tank with water and descaler to the max level
as indicated on water gauge (the scale of water and
descaler is 4:1, the detail refers to the instruction of
descaler. Please use “household descaler”, you may also
use the citric acid instead of the descaler (one hundred
parts of water and three parts of citric acid).
2. Insert the glass carafe onto the warming plate horizon-
tally.
3. Make ensure funnel is assembled in place.
4. Switch on the appliance and allow it to “brew” de-scal-
ing solution.
5. After “brew” one-cup solution, switch off the appliance.
6. Leave the solution stay for 15 minutes and repeat step
4-6.
7. Switch on the appliance and run off the solution until
the water tank is completely empty.
8. Rinse by operating the appliance with water at least 3
times.
1. A clean coffee maker is essential for making
great-tasting coffee. Regularly clean the coffee maker as
specified in the “CLEANING AND MAINTENANCE”
section. Always use fresh, cold water in the coffee
maker.
2. Store unused coffee powder in a cool, dry place. After
opening a package of coffee powder, reseal it tightly and
store it in a refrigerator to maintain its freshness.
3. For an optimum coffee taste, buy whole coffee beans
and finely grind them just before brewing.
4. Do not reuse coffee powder since this will greatly
reduce the coffee’ flavor. Reheating coffee is not recom-
mended as coffee is at its peak flavor immediately after
brewing.
5. Clean the coffee maker when over-extraction causes
oiliness. Small oil droplets on the surface of brewed,
black coffee are due to the extraction of oil from the
coffee powder.
6. Oiliness may occur more frequently if heavily roasted
coffees are used.
REMOVING MINERAL DEPOSITS HINTS FOR GREAT-TASTING COFFEE