Step Three: Mounting the P4 Speaker
Due to the weight of the P4 speaker,it is recommended that the
installation be performed with the P4 speaker laying face down with
the grille removed on a soft surface such as a plush carpeted floor
or the P4 shipping carton. Inspect the area wherethe speaker will
lay making sure that there are no objects that could damage the
speakers or scratch the front of the P4.
1. Position the P4TS close to the P4 speaker as illustrated.
2. Connect the speaker wireto the terminals on the P4 speaker.
3. Mount the speaker to the post by lining up the two threaded
inserts in the back of the P4 speaker with the two outside
machined holes (middle hole is not used) in the post. Insert the
two speaker screws (short) and tighten. Insert the plug into the
unused machined hole on the post.
Note: Do not over-tighten the screws.
4. Take up any slack in the speaker wireby gently pulling the wire
at the opening in the base.
P4 Vertical Mount Assembly Instructions:
This configuration is compatible with Models: P460,
P450, P442, and P430.
•Flat head
Screwdriver
Hardware / Parts:
Required Tools:
•Phillips head
Screwdriver
Speaker
Screw
(short) x 2
Threaded
Machine
Screw x 3
P4TS
Base x 1
P4TS
Vertical
Post x 1
Step One: Attach Base
Attach the base to the vertical
post with the three included
threaded machine screws and
split washers (small) using a
Phillips head screwdriver. The
post has already been threaded
to ease screw installation. Attach
rubber feet to base.
Step Two: Speaker Wire
With the stand still inverted, route
the speaker wirethrough the
opening in bottom of the base,
down through, and out the open-
ing in the post. Use the top open-
ing for the P430 and P442 and the
bottom opening for the P450 and
P460. Leave several extra inches of
speaker wire exposed to ease con-
nection with the P4 speaker.
Split Washer
(small) x 3
Plug
x 1
