Brabender OP12 Owner's manual
Status:
01.06.2022
Static Feeder Calibration –OP12
TECHNICAL
INSTRUCTION
Static Feeder Calibration –OP12
Description
The technical instruction describes the step by step process to conduct the
static balance of the scale of the OP12.
2
Technical Instruction - Static Feeder Calibration –OP12
Step 1
Press the button on the bottom right
Step 2
Press on the Key button
Step 3
Type in the code 08434 and press the Enter button
3
Technical Instruction - Static Feeder Calibration –OP12
Step 4
Choose the scale whose leverage factor needs to be changed
Step 5
Press the second button from the bottom right
Step 6
Press the second button from the top right
4
Technical Instruction - Static Feeder Calibration –OP12
Step 7
Press the button to enter the weight of the test weight, (Example: 10kg)
Step 8
Put the test weigth on top of the feeder
Step 9
Remove the test weight
5
Technical Instruction - Static Feeder Calibration –OP12
Step 10
Press button to send the new lever arm into the system.
The lever arm is now set! Control again with the test weight.
